BMW E60 LCI TAIL Lights

[Artjom]

Hallo, did any one had experiance with changing the front and taillights of an bmw E60 2004 to LCI?

I know coding has to be done by ncs expert.. does anyone know what need to codet and what cables has to be changes?

the cables of the front lights are different..

i have one manual .. in german.. but it tells me to by 2 adapters for rear lights.. and that 2 cables need to be pluged into the LMA module ..


hope someone can help..

thx

[lolo.lolo]

hi

first of all ... only cars after 03/2005 ...theoretical
the pdf is no use in your case.
it can be done but u need WDS and the front connectors for headlights and u need to code the LCM with NCS.

it's a long story.


have fun!

[Artjom]

so whats the solution... have you done it before? i can get some adapters for the front.. do i need to pull cable to the LMA like in the manual from the tail lights..

the coding with the ncs ... what need to be codet.. ?

[batpepi]

i make this 5 month ago,but the car was 2006my and put facelift lights.Need 2 cables for rear lights and need to change some wires.for front lights need other adaptors too.with OPS in retrofits you can make adaptation for new lights.
I have some problems with DRL and the end i make with relay and resistors,but when switch on low or high beam -angle eyes stop to work.
too i not put 2 cables from tail lights to LCM for brakelights and now car have on dash message for this.
i will not be agree to make this again

[lolo.lolo]

so whats the solution... have you done it before? i can get some adapters for the front.. do i need to pull cable to the LMA like in the manual from the tail lights..

the coding with the ncs ... what need to be codet.. ?

hi

yes I have done this "retrofit" a few times.
it works very well without any cable for front or rear lights.
u need only the adapters for headlights.
the entire LCM need to be coded "manualy".

u need a relay for the new "angel eyes" (H8) installed on the output from LCM.


have fun!