PDA

View Full Version : Zafira PSG 16 ECU repair solution



DiagService
15th June, 2011, 11:26 PM
Zafira 2004 Y22 DTR
ECM is in PSG16 Pump

I have a DTC sensor camshaft, this car has no camshaft sensor, but it calculated the speed from crankshaft and speed pumps.
I can not Start motor, this motor have not camshaft sensor.

P0340 Circuit Camshaft position sensor area of

The control device can not synchronize signal camshaft

Joe019
16th June, 2011, 12:42 PM
and?

i dont understand this thread, jejeje

ominimicu
16th June, 2011, 07:32 PM
yes, it s the tipical pump ECU, fix it or replace it.

DiagService
16th June, 2011, 10:02 PM
yes, it s the tipical pump ECU, fix it or replace it.

Have you any idea for repair PSG 16 Pump-ECU

delio78
17th June, 2011, 05:53 AM
may be interrupted cable to sensor

DiagService
17th June, 2011, 04:58 PM
may be interrupted cable to sensor
Zafira 2004 Y22 DTR
ECM is in PSG16 Pump

I have a DTC sensor camshaft, this car has no camshaft sensor, but it calculated the speed from crankshaft and speed pumps.
I can not Start motor, THIS MOTOR HAVE NOT Camsaft sensor.

P0340 Circuit Camshaft position sensor area of

The control device can not synchronize signal camshaft

delio78
17th June, 2011, 09:31 PM
sensor on the pump check band cable
open cover pump remove electronic block
band cable is below
sorry for my English

DiagService
17th June, 2011, 10:08 PM
sensor on the pump check band cable
open cover pump remove electronic block
band cable is below
sorry for my English
I will see and send report.....

goranradovicpg
17th June, 2011, 11:01 PM
in opel small vire is cut .

ominimicu
18th June, 2011, 08:15 PM
yes it s a tipical fault, trust me the sensor it s ok, the ECU is bad inside, open it..Carefully, you need some previous experience on this, OR DONT DO IT. and check for cold broken solder joints, and the bridge wires, you ll see a lot of wires covered in silicone.

elchip
18th June, 2011, 09:59 PM
yes it s a tipical fault, trust me the sensor it s ok, the ECU is bad inside, open it..Carefully, you need some previous experience on this, OR DONT DO IT. and check for cold broken solder joints, and the bridge wires, you ll see a lot of wires covered in silicone.

Same as in modern ABS ECU ...

:beer:

DiagService
18th June, 2011, 10:11 PM
yes it s a tipical fault, trust me the sensor it s ok, the ECU is bad inside, open it..Carefully, you need some previous experience on this, OR DONT DO IT. and check for cold broken solder joints, and the bridge wires, you ll see a lot of wires covered in silicone.
I have Cheked inside in ECU all wires is OK, from pump sensor and crankshaft sensor, with the needle I checked it out carefully....????

fodortms
20th June, 2011, 10:27 PM
You can buy camshaft sensor from a Bosch Service! You need soldering to ecu with four solder points!
BR

DiagService
21st June, 2011, 10:25 PM
You can buy camshaft sensor from a Bosch Service! You need soldering to ecu with four solder points!
BR

Have you manuals from this solderin Photos ????

Zafira 2004 Y22 DTR
ECM is in PSG16 Pump

I have a DTC sensor camshaft, this car has no camshaft sensor, but it calculated the speed from crankshaft and speed pumps.
I can not Start motor, this motor have not camshaft sensor.

P0340 Circuit Camshaft position sensor area of

The control device can not synchronize signal camshaft

bodzio012
25th January, 2012, 09:02 PM
Repair of driver PSG16 somebody have any photo?