MITSUBISH LANCER IMMO

[gadroulll]

here i have a problem . As you can see in dump the key exist in the immobilser memory but car not starts.
i connect x431 and can not read immobox .
i connect sbb not ecu found

With x431 i connect in ecu and say immo prob.

the damage become when someone put in the ignition a key without transpoder.

any solution?

immobox mr309672 x1t13371m

[keygargoil]

it is probably just the sync data in the immo box that is out read the ecu file and post the dumpyour immo box file is not recognised by zed bull tm pro recognises it, if its the immo box i would replace the immo box and write your file to the new box

[wd bau]

here i have a problem . As you can see in dump the key exist in the immobilser memory but car not starts.
i connect x431 and can not read immobox .
i connect sbb not ecu found

With x431 i connect in ecu and say immo prob.

the damage become when someone put in the ignition a key without transpoder.

any solution?

immobox mr309672 x1t13371m


hi
when any one try to start any Mitsubishi without the original key, the car block it ,try this leave ignition on for 30 min and then try to start the car.

[gadroulll]

the car started

[d.zio]

i have the same problem... i read immo box and key with zedbull...i see the tiris data of the key into the eeprom of immobox...
solution is to leave the ignition on for some minutes?
any other advice?
thanks in advance

[achaccha]

eventhough the immobilizer is locked must contact the escanner. I think some botched welding inside the immobilizer or corrupt information thereof.
regards

[d.zio]

nothing happened with ignition on for 30minutes....with zedbull mini i read the key data...with diagnostic i have fault about transponder..can anyone help me?this is dump from immobox

[d.zio]

7EEFB780C0000000
00A5537E0000
TYPE 4C TEXAS WR

[Bllinda]

Where key.tiris format
....
This key is already

[d.zio]

so this key already exists to immobox?

[ayser]

I suffered from this problem so much I did not find a solution , especially if he lost the key and the ignition on more than once without key problem will get better in the ecu to replace the entire system any ecu and immo and key

[aketokediag]

In MATS system, if you tried wrong key on it will lock immo system, even if you try program it back it wouldnt successful, all you need to do is to on ignition for 1hr and start the car.
Regards