hyundai trajet 2.0 , 2001 model immobiliser

[obdmaster]

I have a hyundai trajet 2001 model and immo light flashes for 5 secs with ignition on, then goes out.

Using key programmer i have discovered no keys are programmed in immobiliser.

I have tried reprogramming key using usual 2345 code, but still no keys are programmed.

Is there a seperate immo unit if so where is it located???? or is it just key ecu???

Many thanks

Obd

[joubliss]

normaly it will have a Smartra ECU (immobiliser) in the down behind of centre fascia-low in the right.

[igorr]

maybe this can help you

[obdmaster]

The ecu is keffico type, so is there seperate immo unit or is it inside engine ecu???

[joubliss]

The ecu is keffico type, so is there seperate immo unit or is it inside engine ecu???

must have a immo unit. if not try to read ecu and upload it.

[obdmaster]

maybe this can help you


There is no master key customer lost all keys few months back and someone made new!!!!!!!!

[obdmaster]

There is no master key customer lost all keys few months back and someone made new!!!!!!!!


had ecu open and there looks like no eeps just large mitsubishi chips.

[joubliss]

look for a smartra ecu (immo unit) in the down behind the console fascia at the right.

[igorr]

Behind the centre fascia-low down and to the right. Thats where the 2.0 petrols were or it could be around the steering column.

[naelraddad]

this pic from GDS for target 2003 motor 2.0

regards

[obdmaster]

Ive found and removed immobox read 93lc56a dump attached

think this is why car is immobilised and keys wont program. lol


does anyone have good dump immobox from hyundai shin chang immobox using 4d trandponder

model 95420-31A100
353815
SIS-01B


As you can see from dump looks like pin is 2345, so as all older hyundai use same pin wander if any immobox dump will do

[joubliss]

the code pin sent to u to PM

[obdmaster]

can someone add my 4d 60 transponder to joubliss dump

Data: FF 00 13981910

RESP: 89A2F3 9B93F3

As it wont program in car.

hope thats enough info if its even possible

[Meat-Head]

Sorry only just seen this thread.

Suggest, you grab your zed-bull and try lookking at hayandai/kia pin to vin part on the eeprom menu, insert last 6 of vin - see what damage you cause.

Also, think your going to be correct - just try and only a try - if next to battery some relays, twack with a hammer - had a couple of haundai people carriers - damm - them things that look like voyagers - damm one in tomorrow - damm, yeah 2 now relay next to battery, twack it...

Also use your OBD16pin breakout box, see which pin your programmer is working on, then meter out immobox to diag socket - oppertunity for a butt connecter?

[nazz2]

I think meat head is correct,if you enter incorrect code,the immo gets blocked,leave ignition on,for 1 hour, if you give me last 6 digit of vin,i claculate it for you tmro,with my zbull

[Meat-Head]

I think meat head is correct,if you enter incorrect code,

yeah, but seem to think there is a rumour about hayndai accents having 2345 as pin code. do a search for mpv instrauctions

[obdmaster]

I think meat head is correct,if you enter incorrect code,the immo gets blocked,leave ignition on,for 1 hour, if you give me last 6 digit of vin,i claculate it for you tmro,with my zbull


I think meat-head is talking out of his anus. lol


these early hyundais have 4 digit pin which is usually 2345, as my dump tells.

I did try ignition on for 2hours same result customer took car and my advice to get used ecu set.

I got paid for a little of my time.

[Meat-Head]

I think meat-head is talking out of his anus. lol .

Sorry what did you say about Reno security code programme NOT needing to matter about the vechile type?

Just say it again, that car ECU do not use then stupid TSOP 48 flash memory chips?

[nazz2]

Sorry i was going to check your dump tmro,but yes i have done few early ones on 2345, to be correct.

[gadroulll]

i have a similar problem but the car is sorento ,it use 4d60 here is the dump.

where i can find the pin code?4 digits

[totalkey]

this pic from GDS for target 2003 motor 2.0

regards
what softwer is the pic from?

[obdmaster]

i have a similar problem but the car is sorento ,it use 4d60 here is the dump.

where i can find the pin code?4 digits


Your pin is 2345 same as all old hyundais m8, but unfortunately again dump is useless as its corrupt

[Meat-Head]

Your pin is 2345 same as all old hyundais m8, but unfortunately again dump is useless as its corrupt

Oh that's intreasting - wounder if it's caused by jump leads or something.

*SOMEWHERE* at M-H-M there is/was a bag with a full lock set for a 2002 Hayandai Accent *COUGH* *AHERM* ruled out immo and ecu :roflmao::roflmao: Will have to have a look for it and see if can take a sneaky dump.

Don't get too excited as your dealing with M-H-M - anything usefull throw it out - anything crap save it. Not seen it for OVER 7000 posts - at least.

Pretty sure it's a Kefco or something.

[gadroulll]

here is fix that it worked to be for all of you.
i put 3 keys in memory .i do not know how to put the seguence of byte so i use one key and i swap 3 times the serial number of .key

i leave the car 2 hour with ignition open so the ecu to unlock.

after that i program the new key from huyndai with pin 2345 and car starts .

i believe that the problem is that ecu is locked if not see keys in memory of immo module and unlocks only if see keys in memory .

this job has be done for the dialer of hyundai because dialer try to program a second key to customer and the car not start again . So the dialer now not buy new set for the car

[Meat-Head]

awesome - do you know where the dialer went wrong?
Was it not a case of 'add key'?

What do you mean bu 'swap key serial number?"

[obdmaster]

here is fix that it worked to be for all of you.
i put 3 keys in memory .i do not know how to put the seguence of byte so i use one key and i swap 3 times the serial number of .key

i leave the car 2 hour with ignition open so the ecu to unlock.

after that i program the new key from huyndai with pin 2345 and car starts .

i believe that the problem is that ecu is locked if not see keys in memory of immo module and unlocks only if see keys in memory .

this job has be done for the dialer of hyundai because dialer try to program a second key to customer and the car not start again . So the dialer now not buy new set for the car


I take it that you was successfull be cause cars master key was present when you went to program the keys, these hyundais are a mystery crap system:rolleyes:

[gadroulll]

nop the key master key has been lost .
swap byte mean that if serial 08f39b16 i put in memory 55 f339b15
55 169b8f
55 08f39b16

[obdmaster]

nop the key master key has been lost .
swap byte mean that if serial 08f39b16 i put in memory 55 f339b15
55 169b8f
55 08f39b16


so you put these 3 keys direct in memory by dump???

If so can you please upload your dump, for us to see how m8??

[Meat-Head]

so you put these 3 keys direct in memory by dump???

If so can you please upload your dump, for us to see how m8??


Yesh - agree with that - if you can upload a screen shot and highlight in the dump the keys - this is to help disabled members who are unable to read or write. Preferably with no passwords!

[gadroulll]

its mi file and key that use is 4d60 serial 08f39b16

[Meat-Head]

its mi file and key that use is 4d60 serial 08f39b16

sorry late at night - got a banging head cold.

Wicked image

1) Could you every time you do one - add your own MASTER key off your
own car to then programme other keys in?

2) Can you highlight the bit of the dump with each key serial number - soory bit dim at times.

3) Notice that everybody - NO password - so ANYBODY can learn about these bags of crap - great for pub quizes - get others to pull the key number out the dump.

GOOD UPLOAD

[gadroulll]

do you have a hyundai to read 93c56 and keys to find how they stored there .
dealer manage to progran only the new key in car now and he is not risk to read the memory so i can see the changes in dump

[Meat-Head]

Sorry, just to help others out, just doing a bit of cross thread polanating.

Must admit, should really check the other dumps in other threads first.

Meat

http://www.digital-kaos.co.uk/forums/f178/hyundai-immo-201808/


http://www.digital-kaos.co.uk/forums/f178/hyundai-sonata-2002-petrol-engine-immo-off-115541/

http://www.digital-kaos.co.uk/forums/f178/hyundai-pin-code-enything-else-68462/

[germanml]

Hello, sorry I am needing immo off for Huyndai coupe 2002, ecu kefico , 9030930198f ,any idea??? thanks in advance

[mcgywer]

Hi,
can anyone add this Id 60 to my dump from santa fe 2000 year immo box?

Thanks in advanced

[Meat-Head]

so you put these 3 keys direct in memory by dump???

If so can you please upload your dump, for us to see how m8??

ON TOPIC:-

Looks like the pub singer named Vic has givven up on post cards this year, he is just emailing files from his Vaction home.

Looks like he is having a great time, some photos of an immobox, circuit board

He must have took his USB-UPA and zedbull clone with him and got some dumps as well
as a screen shot of the key TRIS logic.

Nice one Vic enjoy your vaction