i want to copy a toyota 4c texas key

[sideshow]

hi all

im havong a had time geting the corrct chips from my idiot chinese shops

twice i haev ordered transponder chips and they have been wrong

i have a 4c texas key from a 2000 lexus and i want to copy it
so i ordered tpx1 clone chips whihc i thought were correct ones to buy after doing research on here
stupid shop sent me 4c/4d copy chip and when i put them in my clone zedbull they are
4d 60 crypto WR

are these correct as i ordered tpx1

and will my clone zedbull be able to write to the correct chip

also if i have the wrong chips can i buy some of someone here
or someone give me link to where i can get them

thanks

[gwee]

They have sent you the wrong chips m8.

[siyadk]

autokeys.us
has a good repo

[leandroks]

U can buy tpx1 or electronic 4c head;

[Fallen]

Clone zed bull can't copy 4c to tpx1

[sideshow]

ok thanks for the advice
i might just stick to modifying the dump to suit

[rocket ron]

Zed bull clone can copy 4C chip to a Z4C chip, available from most UK wholesalers. cost about ?4-?5

R.R.

[sideshow]

ok do i need any special software
i can i just copy my 4c to a z4c chip using the clone zedbull without plugging zedbull into a laptop

thanks

[rocket ron]

no software just read original and copy, you can even read original and manually enter 4c logic into zedbull later if req ?

[siyadk]

Rocket ron is right, Z4c is special glass chip produced by IEA to copy 4c and bit cheaper than tpx1..the clone can do this..However they come in Blank, once copied it cant be reused.
In very few cases, (1 out of 10) it doesnt copy properly and had to throw them way coz it is not re usable. Otherwise all good

[siyadk]

Also , it is very rare and hard to get. U can get only from IEA distributor and some of them(like in my country) rip you off since they know that u cant get it from elsewhere(even from china)

[super jumbe]

Clone zedbull will not write 4c, I have clone king will copy 4c with electronic 4c head.

[sideshow]

ive given up playing woth this stuff for afew days
stupid hot air blower seems to be taking lomger to desolder chip
not sure if the solder i used to resolder chip is higher heat rating
so i have soldered and desoldered chip 3 times and on last time a track lifted
so im abit over it at moment
i need to be more patient

[poke708]

Hello Guys
I just found this thread, and i am looking to clone toyota g key (type 5) id:60, 96 E9. is it true they cant be cloned ?
if they can be cloned what transponder should i use ?

Thank You in advance

[gwee]

Of course it can be cloned lol

If you can decode page 4