IMMO OFF SOLUTION CLIO 2 SIRIUS 34 HELP

[kitioni]

PLEASE HELP WITH IMMO OFF SOLUTION FOR
RENAULT CLIO 2 1.4 16 V WITH CAN
ECU SIEMENS SIRIUS 34 S118301111 A
EPROM 29F400BB

[yssf]

try this file

[ninja123]

emulator only

ninja

[kitioni]

thanks my frens i try thes dump bat the car dont start

[rafal]

HI ALL.
I have problem with immo clio 2 1.4 16v ecu sirius 34 with can. S118301111A
I bought immo emulator for these ecu and i did all by instruction:
In the addresses from 4000 to 7FFF, find all values 64 C7 or 54 D7
and change these values and two units before them into
FF FF FF FF
Repeat it in the whole map from
4000 to 7FFF
car not start
what can be wrong?
436219
436221
Can somebody check the files please.

[damiano1]

You clear too much :)
436250

[rafal]

thank you damiano1. tomorrow i will try and report

[rafal]

car dont start. is it chance immo off in this ecu?

[pipina]

436590

436592

436593

Use attached file, unplug black conector from UCH open it and find 2x twisted CAN wires (white/purple) cut it from UCH plug and solder it together. Put starter/UCH jumper so you will have starter all time (If UCH don't have right code it will disable starter with that relay). In same UCH black plug pin 5 is immo light cut it so there will be no red dot on dashboard. Be sure to use right julie immo program. If al conected ok on julie power light is on adn code light blink every 2s.

regards

[rafal]

Car started very good. Thanks pipina

[mancinofranco]

friend pipina connect them together from the vehicle side
or side uch?
you scheme?

using emulator?

thanks

[rafal]

I connected together from car side and uch side.
Yes i used emulator

[BusCan]

436590

436592

436593

Use attached file, unplug black conector from UCH open it and find 2x twisted CAN wires (white/purple) cut it from UCH plug and solder it together. Put starter/UCH jumper so you will have starter all time (If UCH don't have right code it will disable starter with that relay). In same UCH black plug pin 5 is immo light cut it so there will be no red dot on dashboard. Be sure to use right julie immo program. If al conected ok on julie power light is on adn code light blink every 2s.

regards

Hi
Thanks solution tested for me

[mrchip]

I connected together from car side and uch side.
Yes i used emulator

Hi
I dont understand about cutting 2 wires,,,need to be that wires cutted from plug and solder together ( pls see my picture) ??
you say,, UHC side and car side,,,how do you that at car side ? cutting from ecu plug or...?
Thanks
496796

[rafal]

uch diagram

[dadal]

Rafal, Thanks Dear Friend for your effort

[rafal]

no problem m8