Astra H CIM programming problem

[tadeo]

Hi gays I have five question regarding second hand CIM programming
1 do I need new key ??
2 I will need pin from car and donor CIM yes ??
I have op-com so can I programme with op-com ??
Thanks

[ALEKOS]

Yes,you can.Guides:
Before the new CIM is fitted, first note the following:
***8226;Security Code
***8226;V.I.N.
***8226;Mechanical key number
***8226;Variant encoding
***8226;High S***d CAN configuration
***8226;Mid S***d CAN configuration
***8226;Low S***d CAN Configuration
***8226;Run a full DTC scan and save the results
***8226;Make sure that the V.I.N. in the other control devices consistent with the car
***8226;Check the security code you have is correct for the car by trying it another module
Reset the old CIM (optional)
Install the new CIM
***8226;Configure the CAN-High, Low and Mid s***d configurations
***8226;Program V.I.N. and mechanical key number in the new CIM
***8226;Program Immobiliser function, (choose CIM installed)
***8226;Program the available transponder keys to the new CIM
***8226;Reset the following devices:
?IPC
?UEC
?REC
***8226;Switch the ignition off, remove the key and wait at least 15 seconds
***8226;Switch ignition back on
***8226;Program the security code in the following devices:
?IPC
?UEC
?REC
***8226;Configure the variant coding of the new CIM
***8226;The final step is to calibrate the steering angle sensor
Finally
The new CIM module is now programmed to the car.
Run a full DTC scan and, remove any remaining error codes and make sure everything is working correctly.
Faultcode B1001 - Electronic Control Unit (ECU) not programmed stored?

If you have this fault there are instructions too.

[tadeo]

***8226;Program the available transponder keys to the new CIM

Thanks but have problem here op-com asking me to program non-programmed key
i wanna use old key
do anyone have that problem before

[daewo97]

swap eeprom on CIM original to SH CIM.....and solve the problem without the need for any recoding

[tadeo]

swap eeprom on CIM original to SH CIM.....and solve the problem without the need for any recoding

Yes but inside CIM is 912dg128
112 legs one

[daewo97]

must replace 93C76