punto mk2 dashboard swap

[donesko]

So I swaped JTD dashboard with punto HGT dashboard (240kmh), everything works fine but display flashes.
So I tried proxy alignment with Multiecuscan (FAILS).
Than I tried proxy with Fiat Examiner and it also fails, but I can connect do dash and see all info.
What are my options to fix this?




Reading CAN configuration data ...
CAN CONFIGURATION DATA:
00 00 00 0D 00 00 00 0F 00 00 00 0A 00 00 00 00
00 00 00 0D 00 00 00 09 00 00 00 0F 00 00 00 09 00 00 00 01
34 36 37 36 38 39 39 38 20 20 20 44 54 53 49 45 45 50 44 45 20 20 01 01 12 0D 00 00 00 09 00 00 00 0E 06 10 01 06 0C 15 07 00
CURRENTLY CONFIGURED CAN MODULES:
Body Computer Node (NBC)
Electric Steering Node (NGE)
Dashboard Node (NQS)
CURRENTLY AVAILABLE CAN MODULES:
Body Computer Node (NBC)
Engine Control Node (NCM)
Electric Steering Node (NGE)
Dashboard Node (NQS)
NEW CAN MODULES:
Engine Control Node (NCM)
CAN MODULES THAT REQUIRE EOL PROGRAMMING:
Body Computer Node (NBC)
Dashboard Node (NQS)
4.10.2013 19:12:57
CONNECTED TO:
Fiat Punto '99 1.9 JTD
CAN Setup / PROXI Alignment Procedure
--------------------------------------------------------------


CURRENTLY CONFIGURED CAN MODULES::
Body Computer Node (NBC):
Electric Steering Node (NGE):
Dashboard Node (NQS):
:
CURRENTLY AVAILABLE CAN MODULES::
Body Computer Node (NBC):
Engine Control Node (NCM):
Electric Steering Node (NGE):
Dashboard Node (NQS):
:
NEW CAN MODULES::
Engine Control Node (NCM):
:
CAN MODULES THAT REQUIRE EOL PROGRAMMING::
Body Computer Node (NBC):
Dashboard Node (NQS):


EXECUTING ADJUSTMENT...
ABS System
EXECUTING ADJUSTMENT...
PROXI ALIGNMENT PROCEDURE
Writing CAN configuration data ...
Writing to module: Body Computer Node (NBC) SUCCESS!
0
Writing to module: Dashboard Node (NQS) FAILED! - Configuration not supported by system error
FAILED TO EXECUTE
Dashboard Node (NQS) FAILED! - Configuration not supported by system error

[nemena]

Hello Donesko!

I had the same problem. Are those dashboards the same type? They look exactly the same but maybe one of them is with hc08, the other is with 95040.. And they are not replaceable.
What was the reason, you swapped the dashes for?

[donesko]

Stock jtd dash is up to 200kmh, hgt is 240kmh, since car si tuned to 200hp i would Like to now how fast im going

[honingkoning]

Make use any free gps apps on your smart phone.

Wbr.

[nemena]

My original dash was with the hc08az32, which was acting crazy, and I wanted to replace it to one with 95040 inside, but could not stop mileage from blinking.
I had to replace the mcu inside the original dash and problem disappeared.
In your case I don't know if there is a solution.

[TULGEYWOODMAN]

mission impossible

[donesko]

what if I use body computer from same hgt?