Problem with autocom Delphi 2013.2 and hardware gold, ds100e

[fvallar]

Hello everyone.
Thanks to this forum, I got the delphi install and verify software, 2013.2
thank you very much
The problem is I have a gold autocom, the two plates, and the system is windows makes me VCI com 4 in delphi but I recognize COM3.
When connecting the test pulse, I get right, but it tells me I have to update the firmware. I give updating firmware and gives me the error of not updating, I think you are looking at the hardware VCI COM4 port and not the port COM3 which is where.
My hardware model is DS100E
Please someone help me

[genius76]

12v direktli or stick in the car when update firmware

[fvallar]

You mean the odbc connect to the car and try the actulizacion.
Now I connect to the odbc drive, the usb to the computer, put the two red lights and gives me the error. The laptop I have him with battery, it does not matter right?
regards

[genius76]

No batery or dinamo no meters usb no meter
I do da bay Bluetooth just litle bit longe
So vci found all serial and hardware ok in gren color?

[fvallar]

Forgive me, I do not understand, can you explain me the procedure slowly
Thanks and sorry

[gazvts]

uninstall drivers from windows
1.plug/connect vci to vehicle
2.connect vci to laptop it will install drivers again
3.open software go to hardware settings test hardware
4.when prompt to firmware update select update
if the vci can not update firmware try using the software version that matches the firmware already loaded in your vci

[fvallar]

Hello everyone
Firstly thank you for the support you give That is the version that corresponds with my DS100E, leave image for more details
My problem is that I have the autocom DS100E gold version 2013.2 and have properly installed and running smoothly.
The bluetooth would have bound and also works.
The problem is I do not actuliza DS100E firmware, in addition bluetoodth not charge me as VCI COM port but as COM3.
Instalale few drivers that you put a link up but not more.
Any idea what can happen.
Also when COM3 recognizes both USB and BT do not charge by the serial number.
I put a screenshot to what you may see.
regards

231706

[tango5]

I think you install software with different serial number from your VCI. Witch is your device serial number?
Also, You go to Device Manager and see in witch com port is your VCI, then manual select this port in software.

[genius76]

I think you install software with different serial number from your VCI. Witch is your device serial number?
A
Right in target i think