Help with connect Carprog Clone to MC912

[vmax]

Hello, i need help how to connect carprog clone with a10 cable to motorola MC912DG128 (from dash volvo s60 2001). how can you have any pictures or description, whether drawn or soldered on dash

[pepi]

Go directly to MCU with A10 adapter, BKGD grey wire

[vmax]

bkgd pin is grey wire or green ?

[vmax]

Pepi, not work :/

[eliasole]

This is from carprog manual.

[vmax]

Eliasole thanks but i try from this manual and pepi but not work

[pepi]

Try to lift BKGD from PCB but be careful ,it must work. BKGD is grey wire.

[vmax]

yes, work but i have a problem ;) i need full flash and eeprom but motorola is death

[pepi]

Here it is flash and eeprom for you.I have read flash with rosfar.
pass on pm.

[vmax]

thanks, what is rosfar ?

[pepi]

HC12 programmer interface.

[verica]

Hi pepi can i have also full flash for this dash

[bodzio012]

Vmax you should clear messeges in your pw

[Maximilian1]

Go directly to MCU with A10 adapter, BKGD grey wire
Hi pepi
I have to read this mcu and not clear whether i should :
1. Desolder mcu off pcb and connect carprog as per above wiring diagram
2. Connect directly to mcu
3. Lift required pins and connect carprog.
Thanks

[vasa]

Is better Bay xprogm or upa usp without desolder or lift pin from board. Carprog is good only als radio code calculator.