1999 honda accord NEED INFO & HELP!!!

[ninja123]

got this damn car with all keys lost, cant find immo box anywhere, had dash out :(

Car has 5 pin diagnostic plug, I dont have anything to connect.

I find immo ariel around ignition and looks like id48 type, but when I opened it, just an ariel :(

Can any one give me some info how to immo off or program a transponder for this old boy? or even k line wire on diag plug would be a start!!!

spent most of the day on this car and got no where :(

pictures attatched.

Thanks, ninja

[yusef]

done one long time ago. if memory serves right there should be a three pin plug in the visinity of five pin plug. might look like its connected but will pull out.
use mvp or t300 3 pin honda

[ninja123]

cant find a 3 pin anywhere near it, had dash out looking for immo box and ecu :(

ninja

[socrates66]

I'm trying to run honda civic coupe 2001
the car is immo off, the owner wants to transponder
the antenna is 9346, read it, and module 67 EEFI,
I can generate chip, ready to start,
in ecu, has 9356, that read, FFFFFFF,
I repeat, the car starts, (immo off)

[yusef]

i am sure you have looked as i remember strucgling to find it.

It was roughly center of passenger side under glove box inbetween glove box dash gap of couple of inches.

The thing that through me was that it was plugged in hence looked like part of some wiring until you pulled it appart.

I will check up on it on Monday

[adamgr]

I did one for a new immo reader not long ago
key were stored in the reader . id48
used the 5 pin socket and old ad mvp to program. I think a working key may have been needed though.

I think this is tmpro module 105

[socrates66]

275042275043275044

[socrates66]

The pictures are from the ecu, pins 6 and 7 up
eeprom L56R 436W.
Antenna down side, has eeprom 9345
Best regards.

[bram380]

This cars use immo baord HIC-FX02. MCU HC805P18. Transponder ID13Immo board on the ecu.https://mega.co.nz/#!GpV3TKqITry fill eeprom 93c46 with all FF.orUse Honda Immo emulator.

[ninja123]

antenna looks the same as id48 system from the outside, but antenna has no eeprom only large megamoss chip, this is id13 older system.

i dont think its possible to add keys via socket on this car when all keys is lost.

thanks for all your info, i will remove ecu and try ff in eeprom.

ninja

[totalkey]

The plug is above the five pins plug near the ecu and maybe it's need to search the wire near the ecu and follow it


iPhone Tapatalk

[ninja123]

There is defo no 3 pin plug on this car, removed ecu, found microchip eeprom 93lc46, filled with FF and car starts:)

Had to remove bulb for MIL and KEY lights from dash too.

Thankyou for all your help.

ninja

[totalkey]

There is defo no 3 pin plug on this car, removed ecu, found microchip eeprom 93lc46, filled with FF and car starts:)

Had to remove bulb for MIL and KEY lights from dash too.

Thankyou for all your help.

ninja

Good to know ninja


iPhone Tapatalk

[ninja123]

This customer has called back and says car is juddering now, is there any way to make a transponder for this car?

ninja

[mojomojo]

Are you sure this car doesn't use an obd-ii connecter! 16-pin. What country destination is this a

[key4man]

hi
Honda cars year 1999-2002 (Accord, CRV, Civic and other). ). Inside immo board

looks like in picture. On this board is 28 pins processor with label.


275473


To disable immobilizer u need to remove immobilizer board marked in red from motor ECU
and install immobilizer emulator .

to weeks ago I made lost key for Honda civic 2001 with x-100 3 plug connector
id 48

[ninja123]

101% not have 16 pin obd - I took out dash to find plug and immo box, so I know there is defo not these connectors or immo box.

ninja

[vanos batam]

ecu inside 1F52W(F52W MC68HC05P18 (28 pins))
transponde t5
also possible immo off

[Meat-Head]

Ninja mate the key reader use your quality voltmeter , measure the voltages on key reader unplug ecu repeat experiment.

also can't see it been down to what you did.

just try offering an id48 chip next to reader see if it learns key as Ff EEPROM

[totalkey]

This cars use immo baord HIC-FX02. MCU HC805P18. Transponder ID13Immo board on the ecu.https://mega.co.nz/#!GpV3TKqITry fill eeprom 93c46 with all FF.orUse Honda Immo emulator.
can you explaine immo off?
fill all fff and disconnected something

[Meat-Head]

ON TOPIC:-

if it has v-tech then if engine light on no Fred (iShit Failiure) v tech

[totalkey]

Please got same problem , how immo off 93lc46?


iPhone Tapatalk

[totalkey]

Here is the connector http://tapatalk.imageshack.com/v2/14/09/14/f52db82ebd621b9be7aa4fc255206f22.jpg


iPhone Tapatalk

[totalkey]

The blue socket


iPhone Tapatalk

[ninja123]

that is 5 pin, we look for 3 pin socket.

ninja

[totalkey]

no is not
is 2 connector and 3 connector
pull it and you will see!!!!!

[Meat-Head]

Total key is your car a left handed one?

[totalkey]

no right handed

[ninja123]

my plug was the same, unplgged it and it was a singlw 5 pin plug, and your car must be left hand drive as bonnet release and foot rest on the left!!

ninja

[totalkey]

yes you right

[autocheck]

ecu inside 1F52W(F52W MC68HC05P18 (28 pins))
transponde t5
also possible immo off
how do you immo off this??

ecu inside 1F52W(F52W MC68HC05P18 (28 pins))
transponde t5
also possible immo off


Sent from my Android using Tapatalk

[obdsystems]

been a tough 1 ninja -
i know the type with immo board within ecu, sure u already know type - its on its own pcb. these honda are around 99 year.
Is 'judding' is your fault - wouldn't be 1st time customer has got confused :beer:


Yeah early ones have horrible diagnostic connectors n better by eeprom (usually).


UPDATE: lols yeah just read prev comments - been there, done that

[ninja123]

been a tough 1 ninja -
i know the type with immo board within ecu, sure u already know type - its on its own pcb. these honda are around 99 year.
Is 'judding' is your fault - wouldn't be 1st time customer has got confused :beer:


Yeah early ones have horrible diagnostic connectors n better by eeprom (usually).


UPDATE: lols yeah just read prev comments - been there, done that


hey steve, are you at alex on sunday? ninja

[obdsystems]

wow time sure does fly

yes i'll be there sunday and hopefully Alan and pinky too?

actually might buy something this year lol

b good to meet up

[Atex31]

I'll be there on Sunday 5th Oct,


Don't forget it has changed venues this year, don't turn up to last year's venue!!!

[ninja123]

So glad you said that, I would have been at the old joint on my own :)

ninja

[Cromwe11]

Small update on this one. After having had one of these to do recently and planning to use an emulater turns out it can be done without. Programmed with mvp pro under system 2 with dongle C. Had a little wobbly fit over which dongle it wanted to use but stick with dongle C and it eventually programs the key. id13 chip and yes this was with all keys lost.