RX350 2010 start problem

[auto diag]

Hello all DK members
this is other probrem with RX 350
All keys open and close doors ; but no sound in the car , on immo light and reflet light on the dash . No signal or light from start - stop butom. i test the butom on another car and it ok
Car can not start
I bypaas fuse 15A P/Point under the dash and use toyota intelligent tester . This is fault code :
B2785 and U1133
explanation : no communication with PMN module
any help to solve this problem ; where can i locate this module ?
Thanks and regards
JOE

[cjawahir]

hello can u explain how this problem happen , and do u have wiring for the vehicle ?

can u also show a pic of the fuse u jump to battery ?

this vehicle is hybrid ?



cj

[auto diag]

Thanks for your repply ; i just apply my test lamp on P/point fuse 15A and radio start then i try to diagnose /
concerning the car , everyting was good when the car park . After moon they trying to start it . Only remote on the two keys
work (open - close door and bonet ), noting are woking in the car (no sound , no light , even the start/sop botom)
after checking fuses all are good
I have not the wire diagram of the car , i'm looking for the rear pin data of power manegement ECU
Thanks and regards

[repairmymodule]

Looks like the certification/immo ecu is damaged. Was there an electrical storm, or possibly reverse polarity on the battery?

[auto diag]

Thanks for your participate
Nothing like that ; sure all keys are good . I pin data of power sterring ECU

[PCF]

can u get another smart key box and write the dump on it?

[auto diag]

thanks
i'm looking for a new smart box ecu
best regards
Zapfack tsobgni