Ford mustang 2015 prox lost key

[Nassreddine84]

Hi mates
I've got a Mustang 2015 all key lost with anti theft alarm active i am not able to clear keys with mvp inspite mvp last software ads222 has the function clear keys but once i click on clear keys it starts siren it is Keyless push start any idea how to pass thru this anti theft system plz help mates this is very urgent the car is imported from usa


Sent from my iPhone using Tapatalk

[Automat]

I had this in my notes, not sure if it works on the mustang though.....

Wait 10 minutes after setting off the alarm. A single horn chirp sounds to indicate a 1 minute OBD link access time period, move quickly!
Connect the scan tool to the OBD plug and start a scan tool session.
Access the PATS Functions to gain security access. Once security access is obtained, the 1 minute OBD link access time period lasts indefinitely. Program keys/fobs as normal.

[Nassreddine84]

Dear mate the hazard light is not switching off but siren sound yes it does switch off so u mean i need to set down the timer directly after the alarm switched off for 10 min and then connect the tester again do i have to disconnect the tester or just wait and leave the tester plugged in?


Sent from my iPhone using Tapatalk

[siyadk]

i think automat meant is to start timer when alarm start horning. when timer hits 10 mins, you will hear , a single horn will beep indicating you have minute to get through the security access

a small tip which you would already know: you might need two prox when you do erase keys. Since i am from same country as you are in..i know it is extremely hard to get these new ford prox keys

[Nassreddine84]

I have the prox keys 2pcs frequency 903Mhz but have u or anyone ever did this procedure on Ford prox because i've been told to do so by Landrover prox and that time it does not work


Sent from my iPhone using Tapatalk

[indienick]

Hi mates
I've got a Mustang 2015 all key lost with anti theft alarm active i am not able to clear keys with mvp inspite mvp last software ads222 has the function clear keys but once i click on clear keys it starts siren it is Keyless push start any idea how to pass thru this anti theft system plz help mates this is very urgent the car is imported from usa


Sent from my iPhone using Tapatalk

does the car have keyless pad on the outside? if you enter the code, alarm will deactivate, then you can program keys. Sometimes TCode can pull the code even if the alarm is activated. Also, check the owners manual for small card to see if the master code is there.

Finally, Ford always has the code written on a label somewhere in the vehicle, though I am not sure where the code is written on 2015 mustang.

[Nassreddine84]

This is 2013 Ford usa coded system and regarding the login i am able to login and i got the outcode by mvp but this code need to be calculated for getting the incode this is the problem there is 2 options NASTF and dealer both accounts i don have anyone has NASTF account may help me ? Please i pay for the code no problem for that


Sent from my iPhone using Tapatalk

[indienick]

is it 48 digit code?

[Nassreddine84]

http://uploads.tapatalk-cdn.com/20160415/d7ab8eef7a967ac22cc6f5d8b679ed8a.jpg this is the outcode
Ford USA 2013 coded


Sent from my iPhone using Tapatalk

[wiffleballbat]

This is 2013 Ford usa coded system and regarding the login i am able to login and i got the outcode by mvp but this code need to be calculated for getting the incode this is the problem there is 2 options NASTF and dealer both accounts i don have anyone has NASTF account may help me ? Please i pay for the code no problem for that


Sent from my iPhone using Tapatalk


Do you have a stand alone remote that you can obp?
I have done that here at least in USA on certain vehicles.

[Nassreddine84]

http://uploads.tapatalk-cdn.com/20160415/c66ba112aee5a0e0d3bd7ab9b6efd76e.jpg this is the remote that i have what do u mean stand alone ? Mate


Sent from my iPhone using Tapatalk

[Automat]

I believe On board "remote only" won't work on his vehicle. Yes, it appears NASTF or dealer Pass-thru is needed here. Unfortunately I do not have NASTF my friend....

[Nassreddine84]

Tell me how there is a 24 digit incode how do u mean can we start it


Sent from my iPhone using Tapatalk

[Automat]

An aftermarket solution is slow in arriving for these vehicles, but I heard Zedfull and abrites is doing them. Anyone verify this?
Sorry this post won't solve your current problem Nazreddine, but it would be nice to know.

[Automat]

This tool claims to do new mustang with prox, with grain of salt I take it. Anyone used it?

http://www.aliexpress.com/item/2016-Newest-FMPC001-for-Ford-Mazda-Incode-Calculator-FMPC001-Pincode-Caculator-Incode-Diagnostic-Tool-with-Free/32613344746.html?spm=2114.01010208.3.264.HqJlaE&ws_ab_test=searchweb201556_6,searchweb201602_1_100 17_10005_10006_10034_10021_507_10022_10020_10018_1 0019,searchweb201603_1&btsid=5f58e317-fb50-4a01-b169-7baba4ee4280

[Nassreddine84]

This tool can not do it mate this is same like NSPC it can just extract the code from the car but this type of coded ford u need NASTF account to obtain the code so it is money waste enjoy


Sent from my iPhone using Tapatalk

[godfathertre]

surely some locksmith member from america can help you if member of forum.

[alex1881]

Zed full is working in that car.

[indienick]

TS if still this card is a problem contact me by PM and I will offer you solution, just have the 60 or 66 digit outcode ready

[Nassreddine84]

It is 24 digit mate so do u still have the code ?


Sent from my iPhone using Tapatalk

[Kinskeys]

OBDStar's X-100 Pro bypasses these if the alarm is off, every now & then you'll run into 1 that will fail to fetch security data, but it's the cheapest option on the market, AD's working on a bypass as well

[malczykos]

If you need alarm off just remove BCM and read original unlock code for door keypad. Code is write on BCM label. Unlock car used this code and then program keys.
Tested in Fusion and Mustang.

[andreixc]

AD100/MVP can do this,
the outcode is 20 bytes long (40 hex digit),
if the alarm goes off wait until you hear the horn and gain security access (quickly).

[pawel88]

I have the same situation. You have to enter the car to close the door. The alarm will be attached. Wait for 5 minutes and turn off the indicators. You turn on MVP and connect to the Mustang until you reach the key programming. you put the key into the slot, you open the door, wait until the alarm stops, wait for the turn signal to turn off.after 5 minutes car will horn two times , then you can start programing



then you start key coding

[cyril]

pls what programer are u using ? Lonsdor can do it for sure and open the door and wait to hear one horn and them program it i try it