Polo mm 2k78x jtag

[lush29]

Hi all. Have an polo 2007 dash 6q0920804. 2k78x mask and i try to adjust odo. I try avdi and no connection. I never come across this. Is avdi not supporting this dashes obd?
Can some one share an jtag connection i have xprog and smok but can not find connection. I also searched around and i can not find anything. I think i seen this connection somewhere on the dp3 but dont have access to it, please help with connection. Thanks http://uploads.tapatalk-cdn.com/20170103/d14b5c2e115c375dd585aa217514592f.jpg


Sent from my SM-G925F using Tapatalk

[teerak2uk]

Isn't there bdm points on rear nr motor
http://uploads.tapatalk-cdn.com/20170103/de47c3f3e5bddb290c72160c17e27b7c.jpg

[lush29]

Isn't there bdm points on rear nr motor
http://uploads.tapatalk-cdn.com/20170103/de47c3f3e5bddb290c72160c17e27b7c.jpg
I have them there. But they are looking a bit different have a look at the pict. Where the 5v cable goes. Thanks for your help. http://uploads.tapatalk-cdn.com/20170103/b41e2662c278de58825f958df89150d0.jpg

Sent from my SM-G925F using Tapatalk

[amigokola]

UPA connection:
5: GND
6: BKGD
7: RESET
9: 5V

[kizagt]

Did you try with digiprog and cabel for mm cluster?
I try on ibiza mm cluster and all ok

Послато са D6503 уз помоћ Тапатока

[lush29]

i dont have the mm cable.
but anyway let me tell yous what happen.
i used amigokola connection , read it ok give to my friend modify odo, then i try to write filles back in and always give me fault for (check bdm connection),with ori filles also.
so i went and bought an different polo dash vdo, then try avdi again to read and not able to read it or adjust odo, so i took the digiwigi clone and did it no prob. then immo off and all ok. but strange why avdi will not connect with this car model,ecu siemens 9.1 try with the MM cluster and with the VDO cluster and both can not connect with immo or read odo.

[teerak2uk]

Make the cable is easy enough