[petchy2010]

hi i have just purchased a 2001 corsa c 1.2 with no dash clocks i have opcom and want to reprogram the new clocks i got to the correct millage but when i use opcom it reads the millage and sets it but then says remove fuse or reset dash and doesnt change on the clocks any1 no how to do this

[PremierD]

Originally Posted by petchy2010 hi i have just purchased a 2001 corsa c 1.2 with no dash clocks i have opcom and want to reprogram the new clocks i got to the correct millage but when i use opcom it reads the millage and sets it but then says remove fuse or reset dash and doesnt change on the clocks any1 no how to do this

Either remove Dash fuse ... Or unplug dash .. then plug back in ....

[marincovich]

Take in acount that you have two fuses that afect the dash. One of them works on the lights of the dash and the other one on the circuit of the dash.The last one is which you have to desconect.Also you can turn off the battery of the car but you must decoder the radio.Good luck!

[petchy2010]

TRYED THAT BUT NO CHANGE IT CHANGES IN THE EPROM MENU BUT NOT ON THE CLOCKS

[fodortms]

Hi!
You need push the km resetter button on the dash, under opcom programming new km continuously! After you need remove the dash or fuse or battery!
Regards

[marincovich]

Did you try holding on the reset kilometer botton during the process about two minuts when you put the new kilometer value?Mines works like that. then you have to cut electrical alimentation(removing fuse)and new km value appears.

[petchy2010]

WHAT FUSE DO I REMOVE THEN BECAUSE IT CHANGES IN THE EPROM MENU BUT NOT THE CLOCKS ??

[caveman_nige]

please type in lower case, type in upper case in the internet is considered to be shouting... Thanks..

[obdmaster]

Originally Posted by petchy2010 WHAT FUSE DO I REMOVE THEN BECAUSE IT CHANGES IN THE EPROM MENU BUT NOT THE CLOCKS ??

When doing it with op-com, follow steps in large window, theyre not very easy to see but tells you what to do m8.

[z786]

listen mate, start from the top
program the mileage, when you press ok to program it, you need to hold the reset button for 2 minutes, you will see the mileage flicker and some other numbers will appear.

then jump out the car and open bonnet.

when you go 2 fusebox, as your looking at the fuses head on, top left hand side there will be a cover concealing more fuses, you need 2 remove the 7.5 amp fuse underneath that on left side.

then Bobs your uncle and Joes your aunty

[yasser]

While prrograming new milleage usig OP-Com, Tahco universal or even Opel Tech II, you have to PRESS and HOLD resset button on instrument cluster until process is done. Then you hae to remove fuse. If you have carradio code or you haven't raddio code, but you can decode it, so you can remove battery power for 30 sec and it is same. Car will not store errors, aslo if there errors you easy can clear those errors with OP-Com.