Eurovox - 5100 - No Signal oe Bad Signal

[chintushel]

Deal all,

I just recently bought Eurovox 5100 and installed firmware. It receive all chanells but after 10 to 15 minutes I get "No or Bad signals" in all most all the chanells. I did deep scan as well, but problems is same even after deep scan. Can aenyone help me to resolve this?

Many Thanks in Advance

[chic.]

Hi m8

check all your connections are tight and remove any splitters

[chintushel]

I have checked all connection and there are no splitters. Pls guide me to resolve the problem

[DELFOR]

Hi mate, was in a similar sitution yesterday. I performed a deep scan with sy rate for your area and inputted the correct details start/stop frequency rate as seen on picture 5 on the following link

GUIDE: Eurovox Scanning Settings

I have the quota of channels now

[chic.]

try reflashing then factory reset delete all channels then do a deep scan on the symbol rate for your area ps is it all or just some channels ie are the fta channels ok

[chintushel]

Hi Chic,

Thanks for your reply,

is SR 6.887 for london? becasue in miy box it was 6.952. Wheather I need to change to 6.887 and then Fast Scan / Deep Scan?

Thanks again

[chic.]

all boxes have 6952 as default i have checked a few forums and found that london is 6952 but you can try 6887 and see if it helps and its a deep scan

[chintushel]

I have tried 6887 and 6953 both but still same problem, can anyone help me please?