[andy-h123]

hi i have just bought a starview super usb box
i have upgraded to the firmware v1.02 and tried to run the automatic scan but it isn't finding any channels
anyone any ideas?
cheers

[andy-h123]

can i just add that the box did scan and find channels with the firmware that was on the box when i got it (free view only)
i have tried the v1.01 version too and has the same problem
i dont seem to have the emu option in my menu either
cheers

[satsmo]

Press menu, type 1570 on remote and turn keycode on.

[andy-h123]

cheers, will give it a try when i get home...

[andy-h123]

nothing happening still....
checked cables, comming out same booster as modem (tried swapping em)
still has a "level" 0% and "Quality" 0%
and not finding any channels

[cactikid]

is there an option of where to plug ur coaxial cable in,=cableinput on previous models.scanning right provider?i think factory reset first,power off box,then autoscan again and emu to on.

[andy-h123]

yes the coax is in the right place
had it set up with the freeview for a week before i got my memory card (to upgrade)
have tried factory reset and the reinstalling flash upgrade many times now.
showing no signal and no quality...

i only have three options in the hidden menu though.
can't find the "EMU" option, is this in the hidden menu?

cheers

[satsmo]

Do you have a live feed, presume you have if your BB is live? Do a scan from the direct feed, i.e. no splitters. As said it doesnt say EMU it now says Keycode on or off.