Electric gate will close but not open ???

[bigkey]

Hi guys, any help would be appreciated.
I have a 2 panels electric gate; the right panel works fine, but the left panel will not response to the open button. However, if I open it manualy then it will close with the remote.
I open the control board but dont know what to look for, All I can see is maybe something to do with the 4 clear plastic boxes "switch" response when I press the remote.
Any suggestion would be appreciated

[Meat-Head]

would guess either 24 jolts or mains!

[bigkey]

Thank for your reply, it's a Elite Swing Gate, 240 down to 24volts. I checked and reconnected all wiring. Both motors on each gate panel has a limit swith, nothing in their way.

http://au.search.yahoo.com/r/_ylt=A0oGkmhgt5VQwU8Aq_8L5gt.;_ylu=X3oDMTByZ3RtN3J1BHNlYwNzcgRwb3MDMgRjb2xvA3NrMQR2dGlkAw--/SIG=12hqrccjo/EXP=1352017888/**http%3a//www.ata-aust.com.au/content/%3faction=getfile%26id=558

In the main control board there is a row of 4 clear plastic switch boxes, when I press the remote, the switches in those 4 clear plastic box jump up & down; I suspect 1 of those is faulty but dont know how to identify the faulty one.

[Meat-Head]

them clear switches sound like relays
ln bed too lasy to look type relay on ebay look at photods

[Meat-Head]

tossing phone i'll write that bloke all again, plastic crap


jok & me both say same look at nymbers guess omron 24/123 24jolts and that layout.

can you uplos d photo & press thanks botton.

[mirandasieck]

Show it to an electrician. May be he helps you to sort out your problem.

[Meat-Head]

here, flip down clip yank like chuff and swap for another




OR check the soldering on borrom




your link no work atm.

is there one set of 'fingers' in these or two?



ignore 3rd on - 3 phase

[bigkey]

Thanks Meat-Head, I'll take photo and post here

[Meat-Head]

if your doing that then 2x 'far' shots of the board and two close ups of the board. - both sides

[manster]

Where are you ? if your local perhaps i could look at it for you /

[bigkey]

Where are you ? if your local perhaps i could look at it for you /

I am Down Under, Brisbane Queensland

[bigkey]

if your doing that then 2x 'far' shots of the board and two close ups of the board. - both sides

It's raining in the last few days, the weather man said wont stop until Tuesday. Hope I can do it then

[Meat-Head]

I am Down Under, Brisbane Queensland

OK, not his MO, but use the STALK botton and look for member Fallen.
(there are others).

Chances are he is ONLY 10,000KM away from you, see if he can assist.

[Meat-Head]

Would like to ask for a fresh card.

Oh bugger it's a 'bump' card.

[johnboy1974]

Sounds like a safety circuit is operating here. Try to identify the safety circuits on your electronic panel and link them out. Safety circuits on door and gate leafs generally are normally closed. Link out any safeties connected to the gate that is not opening.


Sent from my iPad using Tapatalk HD