A solution when can't finish upgrading for Estar800se
when you upgrading but can't finish it
you can try this as follow
1.connect receiver to pc with ethernet port.
2.press standby button then power-on.
3.open DCC and make a telnet with receiver.
4.in Misc --Flash Sector Recovery, change DISABLED to ENABLED
5.then save it
6.now open your browser and try upgrading again.
gook luck.
you can try this as follow
1.connect receiver to pc with ethernet port.
2.press standby button then power-on.
3.open DCC and make a telnet with receiver.
4.in Misc --Flash Sector Recovery, change DISABLED to ENABLED
5.then save it
6.now open your browser and try upgrading again.
gook luck.