vu duo v3.0 STARTING help pleaaaaaase

[scottj130208]

have a vu duo clone unfortunately v3.0 stuck on starting
dont have any hdd connected all wires pushed fully home psu inside seems fine intact
the box will let me flash through usb but once flashed and reboot box hangs on start
tried various images including stock image still hangs on start any advice or is thuis fit for the
bin me thinks

[rjhmk]

use putty with serial port connection(RS232) to reboot receiver

[heidthebaw]

I have the same issue, how do I reboot using putty please?

[digicon]

I have the same issue, how do I reboot using putty please?

If your not very tech minded then get hold of Lee's software from Goldwafers called VUCC which has the telnet protocol/putty built into the friendly GUI

Just type in your IP address of receiver username and password and press the telnet button wait for it to connect and then type 'reboot'

its as simple as that:

Vucc.jpg

[lincsat]

Or power off the box for 30 seconds and try again - that usually works.