dm 600 pvr

[gothi]

hi all,after many attempts to load jade pli image on dm600 pvr, i have tried numerous times with varios versions of dreamup but have had no success.i have done every thing in the guide for flashing dreambox with dream up, i connect cross wired null cable to the dm 600 press connect turn on power,message says time and dm600pvr nothing else happens,on the command side in dreamup the only button highlighted is the disconnect button,the flash and exit buttons are not . any ideas on what iam doing wrong,help would be greatly accepted

[on_the_jazz]

Have you tried on another pc? Was there no default image on it when you bought it?

[krazylegz]

try via telnet m8

heres some instructions

Slightly different to other dreamboxes. You can either use the Dreamup software (takes ages) or use the method below instead.

1. Boot the box, goto the communication menu and note the ip address.

2. Run DCC, connect to the dreambox. Once the network is connected ok, click on the the 'Telnet' option.

3. In the telnet window, type the following, pressing <return> at the end of each line.

mount /boot -o remount,rw
rm /boot/*
reboot

4. You should now get a message saying that the Dreambox is rebooting.

5. Wait a few seconds and then run Explorer (Firefox or whatever) and enter the ip address of the Dreambox in the address bar.

6. On the screen that appears, choose the 'Upgrade firmware' option, find the .nfi file and click the 'Flash' button.

7. Once the progress bar reaches 100%, reboot the box

all done