Eurovox 5100 PVR srcambled channels after factory reset.

[tayzer]

Hi, I did a factory reset on my Eurovox 5100 PVR so I could do a re-scan because some of the channels stopped working.
As it was suggested on this site a reset and re-scan should sort it out.
After doing a re-scan all the scrambled channels are now not working.
I'm getting the 'scambled channel' message on all the scrambled channels. Free ones are OK.
Is there anyway of getting the box to re-calculate the code.
I have tried leaving it on a scrambled channel for a while to see if it will unscramble it but I'm getting no where.
I remember when after scanning the box when newly flashed it said something like. "Updating code, please wait."
Is there anything I could get the box to update the code as there are no options to enter any codes manually.
I do have the latest firmware and that has been working fine since I updated it a few weeks ago.

Any ideas???

[satsmo]

Have you checked to see if emulation is on?

Press menu - Press OK - type 1968 on remote - check to see if it is enabled.

Hope you are in the UK also.

[tayzer]

Thanks for the response satsmo.
Yes I'm in the UK.
I'll give that a go.

[tayzer]

Nice one mate that seems to have sorted it.

[satsmo]

No problem, enjoy