Magic Dash CAN

[dyc]

Also on RB8 clusters? Pin code reading, milage changing?

milage ok but pin rb8 need update bosch level

[d2mike]

Hi,

I have a mdc clone, which is not working

Flash mcu1 2.19
Flash mcu2 3.26
Mdc version 2.35

Software shows me under hw-info:
Mcu1 nothing
Mcu2 crc unknown
Sn off

Bad software or interface?

Does anyone have working version for me?

Thanks.

Cheers

[d2mike]

Here's a screenshot.
Cannot read rb4 and rb8.

[Apolo29]

Here's a screenshot.
Cannot read rb4 and rb8.

Have you tested on VW cars, i`d really like to know if it works ok with 24c32+NEC in Bora, Passat and Amarok.

[d2mike]

Tried it on 2 Audi clusters.

[dyc]

Here's a screenshot.
Cannot read rb4 and rb8.

Original working without problem

[d2mike]

Original working without problem

So, do you think the clone is bad?

When I try to read EE from RB8 it always says "Sec in progess" and nothing else. I can wait a couple of minutes but nothing changes

[cosmind]

you can update flash to latest version. I have clone and tested with latest flash and software on bora 2003 and edc15, edc16 (K line)

[d2mike]

you can update flash to latest version. I have clone and tested with latest flash and software on bora 2003 and edc15, edc16 (K line)

Hi,
thanks for your reply.
What do you mean by update flash?
Mcu1? Mcu2?

What about the software? Maybe my one is just programmed like rubbish. Can you send me your version?

My interface looks like that:
http://www.auto-tool-shop.com/images...-dash-5880.jpg

I just tried again to read a RB8 but nothing happens

[alex_SW]

use clones,and u can get a broken dash.....

[d2mike]

use clones,and u can get a broken dash.....

Great answer mate!!!
So what about update flash?

[autofan1965]

This topic is about MagicDashCan and I think only MagicDash is cloned. I can advise You buy original MagicDashCan because it is really nice tool.

[dyc]

Its very sad that people buy chinese not working tools when original one costs are few hundert euro like mdc for 300 euro and they try to make clusters that when broken cost for repair is eg .1000 euro

[gedas8899]

You right the orginal coast 369eu with shpping an clone coast 220 usd i think it is not big diferent.

[d2mike]

Its very sad that people buy chinese not working tools when original one costs are few hundert euro like mdc for 300 euro and they try to make clusters that when broken cost for repair is eg .1000 euro

You are right mate, but you can also buy tools for a couple of hundred dollars and then they don't work properly. Like Vdc I bought last year for 900$. just rubbish! Therefore I try at first a clone and if I like this tool I buy original.

My mdc just cost 50$. And I think I won't buy it because it's also just rubbish. Sorry guys...