renault fenix5 im*o

[kire106ka]

The rule is if immo light no flashing immo off just cut wire 35 before plug ecu to car
Repeat procedure onse more to be sure no harm to ecu.

[thurgau]

try this method first very easy ,post results please

Hi guys,
Working 1st easy solition for me ECU lamp stay on
But i've tried 20 times these procedure, last 5 times with sliding tweezer. Tomorrow i will test on the car and reply the result.
Thanks a lot,
Regards

[OalikO]

soultion2fenix5.rar working good with it.
SDC11790_1.jpgSDC11791_1.jpgSDC11792_1.jpgSDC11793_1.jpg
Renault_Megane_1996_S105300104-D_ORI_GOOD.zip

[estate]

does this work on 2000 year clio 1.2 8v?

[javiercj]

try this method first very easy ,post results please

hello

thanks by information

but i undersant "you have 9 pins either side,so 9 on A and 9 on B, short 1A with 1B then 2A with 2B all the way till 9A and 9B.holding each for at least 2 secs, engine mngt light should go out,car will then start."

please explain

thanks

[javiercj]

cut immo wire to stop immo causing immo off status in ecu usually pin 37, ign on follow procedure in txt file.

hope this helps

hello

i can explain the method of the pin ? It is about flash o eeprom?

thanks

[javiercj]

hi guys, had a 1999 megane scenic 1.6 8 valve with immob light flashing, transponder in key, both keys not working.
After i eventually removed the rubber floor mat from the chip, i wired up on bench and I shorted pins 1-9, had to do it 7 times before my light stayed on.
Cut pin 37, fitted ECU to car and worked first time!!
Thanks to all who have contributed to this thread, once again, great work guys!!
regards, the ninja

hello

i have some ecu and car

Can you explain the process to short pin?

thanks

[panos_k]

Only the second method worked for me.

[didi_du_93000]

Beter and faster with 0% risk ------>>>> USE Renault DECODER for Fenix 5 and cut immo wire... This ECU can work without immo code inside

[javiercj]

the solution wizz2c

working perfect.

thanks

someone can yo say these solution is tested in ecu safir - sagem etc??

[javiercj]

Thanks wizz2c,

This solution works perfectly on SAGEM SL96-9.

Regards.

hello tioum

how is process in the ecu sl96-9

i have unit ecu sl96-1 will working?

thanks

[kugglefischer]

Hi
28F512 needs to be shortwired right? There are 4 sides each with 9 pins, and both right and left was noted with B and upper side also.

     1    B   9
      ---------
      | flash  |
(?)B|          |B (?)
      ---------
      1    A  9

BEYWEEN 1 AND GROUND AND 9 AND GROUND

[taxo1965]

Hi,
I need immo off file for Renault Safrane 2.0 16v y96.
ECu is:
SIEMENS S113721102 B
HOM7700868318
7700103799

Tried solution2phoenix5, not working.

thanks

[ivankurtev]

ECUs, that cannot operate without immobilizer code stored in memory:
some of FENIX5 for LAGUNA/SAFRANE 2.0l 16V,
all of SIRIUS32 except for KANGOO 1.4l 16V,
LUCAS DCU3R, Bosch MSA15.5 and EDC15C3;

this means that it is need emulator

[taxo1965]

thanks and how to make an emulyator?