Ford Escape 2009 odometer

**Sergo76** · 25th March, 2010, 08:33 AM

I got a MCU MC9S12HZ256VAL is it posible read it with x-prog m ?? and how to connect it to programmer.
Thank you!

**maxzzz** · 25th March, 2010, 08:41 AM

Originally Posted by Sergo76

I got a MCU MC9S12HZ256VAL is it posible read it with x-prog m ?? and how to connect it to programmer.
Thank you!

Greetings, whether check up paths reach socket BDM

**Sergo76** · 25th March, 2010, 09:38 AM

am not sure. is ti the same on all ford?? thanks.

**viejomatius** · 27th January, 2012, 08:45 PM

it can be done by obd2

**digimile** · 27th January, 2012, 10:40 PM

hi
connections are just opposite to the connection in picture and upa can do this in just 5 min...
thankx

**claudio35** · 15th October, 2012, 02:42 AM

It can be done with upa? Work? or only xprog-m?

**PremierD** · 15th October, 2012, 08:58 AM

yes mate UPA does read it ..

**claudio35** · 8th December, 2012, 06:03 PM

Carprog 4.01 clone work obd2 direct? ford escape 2010

**ttzag** · 8th December, 2012, 07:31 PM

Can R270 do this mcu?

**norbisko** · 22nd August, 2013, 09:18 PM

IS this the correct way ?Ford Escape 2009 BDM.jpg

**PremierD** · 22nd August, 2013, 09:30 PM

No mate ..................

**norbisko** · 22nd August, 2013, 10:18 PM

Originally Posted by PremierD

No mate ..................

What is the correct way, last time I tried to figure out on my own I ****ed a ford dash..

**janushaan** · 23rd August, 2013, 02:41 AM

yes you can read with x-prog used the diagram instruction,, i read it fine

**claudio35** · 23rd August, 2013, 03:15 PM

Is same top, work

**PremierD** · 23rd August, 2013, 04:08 PM

Originally Posted by norbisko

What is the correct way, last time I tried to figure out on my own I ****ed a ford dash..

Look at the position of the four wires relative to each other ... thats how most if not all of them are.. (not your picture) ..

Thread: Ford Escape 2009 odometer