Probably bad solder job. Vag edc15 suite corrects checksums before qrite moded file to disk.
Hello everyone I have a problem with this ECU I desolder the chip 29f400BT save file do the file in VAG EDC Suite 15 only hardcut and EGR off after that I check the checksum of file correct it first with efisio not work than I use win Ols 1.500 and the problem is that the chceksum is corrected but when I write the file to the chip car not starts no glow plug I do it many times different methods and nothing work I don't now where is the problem right now , also I use a XGecu TL866II plus programmer with sop 44 adapter
Probably bad solder job. Vag edc15 suite corrects checksums before qrite moded file to disk.
upload both files
Ok I do that
It is the EDC15P-6.3.2 larger case ECU. Sometimes the CRC from the VAG suite and even from the old OLS did not work.
VAG.jpg
Last edited by raceshadow; 4th October, 2023 at 08:37 PM.
IF I HELPED YOU, PRESS THANKS AND REPUTATION BUTTON!!!
ok this is the file original one and my file can somone check the files?
Last edited by bobolin4o; 5th October, 2023 at 02:12 PM.
NO PASSWORDS FOR ANYONE, EXCEPT THE RECIPIENT OF THE FILE !!!
If your PM box is full, clean it right now...
Otherwise, your requested file will be deleted... for ever!
here is the file that i read from ecu
Here is your mod, with corrected checksum with genuine, up to date WinOls
BTW, you can use Ultimo too...
NO PASSWORDS FOR ANYONE, EXCEPT THE RECIPIENT OF THE FILE !!!
If your PM box is full, clean it right now...
Otherwise, your requested file will be deleted... for ever!
jakuber472 (7th October, 2023)
here is your file chks ok
https://mega.nz/file/UaYEBL7K#Of5dQW...mk4vM7ZvjJIKMk
WinOLS 5, FGtech, Piasini, Powergate M, Byteshooter, OptiCan Dual II, EVC BDM, VCDS, BeeProg+,Ktag, Kess V3, Autotuner, Bflash
Fileservice
no thanks no pass
jakuber472 (7th October, 2023)
Ok thanks I will try both the file to see if it's works
The most easiest thing to do would be to swap the ecu to 038906019CJ, just turn off the immobiliser in that ecu and you're good to go, everything is the same, except that the 019CJ ecu is programmable via OBD port
If my post was helpful, don't forget to press thanks!
jakuber472 (7th October, 2023)
Bookmarks