hi Skoda Octavia NEW 2008
km problem dash 24c32+cdc3297g
rosfar R250
UNABLE TO ESTABİLİSH A lNK WİTH THE PROCESSOR
???
hi Skoda Octavia NEW 2008
km problem dash 24c32+cdc3297g
rosfar R250
UNABLE TO ESTABİLİSH A lNK WİTH THE PROCESSOR
???
lift the right pin from xtal
BLUE AND WHITE LİFT REMOVE BUT
SAME *ROBLEM
XTAL PİN NO LİFT ?????
So.... lift the pin of XTAL
XTAL LİFT
RIGHT OR LEFT
pictures DO YOU LOOK AT
PLEASE
Last edited by polat; 18th June, 2010 at 06:48 AM.
Yes, lift the pin where goes the red cable, but let the red cable on pcb.
Did u try this polat? Was it successful?
I tried on 3 occassions to do a golf 5 with r250 interface but I was unsuccessful. However I did not lift the pin on crystal as I was unaware that this would possibly help!!
It would be great if you could let us know the outcome pls.
And just thought i'd mention that if pin 118 snaps off processor dont panic.....vehicle will start and run fine although you may not be able to alter mileage after this!!!!
2007 2008 NO PORBLEM (GOLF5 JETTA PASSAT CADDY)
LİFT PİN
BLUE AND WHITE
NO XTAL PİN
FOLLOW VIDEO RAR OK
BUT MY PORBLEM SIKODA OKTAVYA
Anybody solved this problem with
Skoda Octavia
and message:
UNABLE TO ESTABLISH A LNK WITH THE PROCESSOR
Tried to lift xtal pin, but no sucess...
Mikeli
i have same problem with my r250 and octavia 2008 dash, anyone have solution for this or can i do this dash if i program 24c32 in service mode and after that program new km?
Last edited by gizmo666; 5th November, 2010 at 10:13 PM.
i also try to lift xtal and blue white wires pins but still no connection... any other solutions??
i think it was cdc3217, i dont have this tacho here right now but i am 99% sure at it was cdc3217 and 24c32 eeprom..
NEW is nec+24c32,
i can change for you,upload you ori dump!
Bookmarks