Hello everyone,
I have a little problem with my car. I tried to read immo eeprom with CH341A and TL886 PLUS II but in both attempts my result is FF FF FF ................... FF from beginning to end. Tl 886 has pinout check so wrong connection isn't possible.
I am reading chip with clip - not any dedicated adapter, because i don't want to solder the eeprom memory.
Did anyone of you had similar problem?
Best Regards
marecki88 (29th January, 2024)
Hi again,
I desoldered the eeprom chip and i was able to read the data.
In attachement I'm sharing two bins - original and immo off sollution calculated by me.
Can anybody with bigger knowlegde than me (amateur ) take a look at those 2 files and tell me did I made it good?
Last edited by marecki88; 27th January, 2024 at 03:45 PM.
marecki88 (29th January, 2024)
Bookmarks