VALEO J34P ECU original ktag flash 1.1 and 1.4 engine

[almal]

Depending on engine type, you need to flash one of these two MPC with KTAG . one for KFV 1.4 engine and other for HFX 1.1 engine.
the third file is IMMO OFF 95160 eeprom if your original eeprom is corrupted.
all files are tested by myself and all works.
password will sent in PM after thanks and rate thread.

[ricked]

Depending on engine type, you need to flash one of these two MPC with KTAG . one for KFV 1.4 engine and other for HFX 1.1 engine.
the third file is IMMO OFF 95160 eeprom if your original eeprom is corrupted.
all files are tested by myself and all works.
password will sent in PM after thanks and rate thread.

you need to post software numbers else these files are of no use because there are over 50 software variants of j34p
and also st10f273 st10f275 can be in the exact same ecu with same hard and software numbers you only need to adapt them with hand