hello, I received the second vagdash k+can from china.
this one has the folowing configuration:
rs232(com) ---------- obd
1 ----------------------16
2 ----------------------7 and 8
3 ----------------------14
4 ----------------------6
5 ----------------------4 and 5
6,7,8,9 ------------- not connected
tomorow I'll test it and will post result
best regards to all
Software Installation
- uninstall the vagdash software first if you installed it before
- connect the vagdash cable with the computer
- install driver first. make sure select USB port, NOT COM port!
- then install the software
- connect to car.
- start software
I dont found any car with edc16. must to wait.
I will post result soon
regards
Hello again. I tested vagdash k+can 4.22 on Skoda II
changed km on EDC16 and all it's OK.
Did you maybe tried newer version with v5.05 inf you have? 5.11 ?
Hello . I tested vagdash k+can 5.05 on VW Touran
changed km on EDC16 on Tacho and all it's OK.
Video attached. RapidShare: 1-CLICK Web hosting - Easy Filehosting
hi 16eddi67,
which interface did you use with 5.05 software and where did you get it?
thanks...
im sorry mate but i didnt see you change the km in edc16, you just read the chip??
"I always tell the truth. Even when I lie"
"We Taking Over, One City At A Time"
merci a vous pour vos reponses
Hi,RCS CS VAG Dashcom+can V5.05,
Hi, Z746 Reads and writes
Hello to everybody. i use 5.11 software, but i think that is important to know if you upgrade the box with 5.11 you can not downgrade to old one, because the software make firmware upgrade to the box. i make my black cable like COSMIND write
rs232(com) ---------- obd
1 ----------------------16
2 ----------------------7 and 8
3 ----------------------14
4 ----------------------6
5 ----------------------4 and 5
6,7,8,9 ------------- not connected
and i hope to came in my garage some car to try what i can do with my blue box. Next week i will post my result.
Bookmarks