Quote Originally Posted by doslamer View Post
i have the same problem and i fix a little bit, but i think that my software is confused because i connect to 'vw beetle' and read some data but nothing else can do ?!?!?!

first of all change the black cable, original cable pin outs is not correct, when i switch to the car after 3-5 minute my blue box start heating very much, after changing of the black cable everything is ok. i make cable by myself(first i call and ask the provider for pin outs) here it is :
rs232(com) obd
1 ----------------------16
2 ----------------------7
3 ----------------------14
4 ----------------------6
5 ----------------------4 and 5

pin 2 of RS232 is switched ONLY to pin 7 of obd.

now i can connect to cars without a problem but can't do many thins.
if somebody can tell that maybe my software is installed wrong.
any advice will be help full.
hello, I received the second vagdash k+can from china.
this one has the folowing configuration:

rs232(com) ---------- obd
1 ----------------------16
2 ----------------------7 and 8
3 ----------------------14
4 ----------------------6
5 ----------------------4 and 5
6,7,8,9 ------------- not connected

tomorow I'll test it and will post result

best regards to all


Software Installation
  1. uninstall the vagdash software first if you installed it before
  2. connect the vagdash cable with the computer
  3. install driver first. make sure select USB port, NOT COM port!
  4. then install the software
  5. connect to car.
  6. start software