i use gq4x usb programer also have a wellon vp490
gq is quick and cheap and with adapter works fine on both f200 and f400
i use gq4x usb programer also have a wellon vp490
gq is quick and cheap and with adapter works fine on both f200 and f400
Last edited by racin-snake; 31st July, 2010 at 10:25 PM.
Today is the Tomorrow you worried about yesterday ......Was it worth it ?
Hi
Received my willem adaptor and did my first read on 29f400 chip.
Seems to work great.
I have been using GQ-4X with adapter. it is good and reliable.
check this website:
A low cost EPROM EEPROM MCU Atmel Microchip PIC I2C SPI programmer online store
I use Xeltek SuperPro 3000 and never had problems with reading flash,eprom,mcu... This device have all adaptor one to one and you can make it you self.Reading and writing is 100%.By the way I have Galep4 too but Xeltek is much better.
Gq-3x and gq-4x work fine for that. Cheers.
I'll try it - New EZoFlash+. Parallel memory programmer.. Now the stage of assembly. Assemble, test it, tell about it
Sorry for bad English
What you can edit the downloaded dump 29F800 or 29F400?
So need a program for editing calibrations in the dump.
Sorry for bad English
hello ! I have some problem width my psop 44 adapter in my pcb 3.5. i can not erease the 29f400 but i can read something !
I try to make shore if the pins are good contact and it seems ok !
this is a 29f400 from a bosh edc15 Peugeot 206 hdi !
I install the newest willem 5.5 and I see some diferences in the 97ja and the 99d8 !
why ?! is there any reason ?!
I gona lef one attachement !
if somebody cant help me ![IMG]file:///C:/DOCUME%7E1/VIRALA%7E1/DEFINI%7E1/Temp/moz-screenshot.png[/IMG]
thanks in advance !
Try to select a device Flash 29/39/49Fxxx,
and select 29Fx00 8/16bit,
then select AM29F400.
Do not forget to attach 12Volt DC power supply.
Is this well read? anyone to the rescue?
Download VOLVO s60.BIN from Sendspace.com - send big files the easy way
Sent from iPhone 4S
i use wellon vp480 so far had no problems with any chip including the am29fxxxx series.
7.31sec@203.3mph
PROGRAMMER EEPROM
i use willem with 98D12C3 soft version
PERFECT
EzoFlash HW v4.5 is the best solution for smal amount of money , it work better then willem and last willem SW with it.
I was make and test many many times and newer false.
Always do ID first and if you dont get right ID from device do not program !
Check connection's and test again.
Regard's
[I]Automotive Electronics Solutions
Mercedes-Benz Reverse Development Engineer ...
Mercedes CFF 2010-2017 CFF all models all modules
Vediamo help flashing over teamviewer ...
JLR SDD online + offline ...last official ...
Bookmarks