Zed-Bull clone users, look here!

[seregka]

Hi SEREGKA

Thanks for the pictures!

I tried to connect the atmega to the board itself via all ports (JTAG and serial to BEEprog,ICSP to usb asp programmer to SINAProg without success.
Atmega is completely locked, I can't even read the ID of the chip.
Is it with the adapter qfp64 to dip40 that you are here to read and program the atmega in the ZIF socket on the beeprog?
The zif socket should work with ports for parallel programming.
It may make sense to try resetting the lock bits with an AVR doctor!

described everything here
1) Buy a new ATmega2561 "buy a new one"

[seregka]

Hi SEREGKA

Thanks for the pictures!

I tried to connect the atmega to the board itself via all ports (JTAG and serial to BEEprog

BeeProg ??? you have a BeeProg !!! if I had a BeeProg, then my life would be good with such tools, I would be ashamed to ask about the problem with the firmware there is some atmega
PS: I dream of BeeProg.

[abdigoo2016]

hi, this is the secret board zed bull scematic

think you my friend

[obeidi]

chinese zed bull is good for hyundai/kia car ?

[musti418]

chinese zed bull is good for hyundai/kia car ?

china zedbull no obd

[TTR]

Could somebody give me the Pinout on Jumper 5 that i can use Jtag to programm the Atmega2561
or i use usbasp its no matter (i hope) ;-))

Thanks an Greetings TTR

Thanks to Dacha i used his Photo