sagem SL 96 decode

[simic82]

I tested your solutin work!!!!
thanks autorisp!!!!!

[javiercj]

It 'easy to do.
You need a cable with a resistance of 100 ohms in series.
Connect one end of the cable to ground.
Connect the other end of the cable to pin 22 of flash and turn on the key ( Key ON state ) .
5 seconds after disconnecting the cable and you should hear the stepper motor that moves .
If not, redo the operation to pin 24.
In this way we causes to microprocessor a 'Bus Error' which erases the EEPROM inside the micro and (on this ECU) the reset of 'im * o.

hello friends


please


i need to make immo off in car peugeot 406 1.8 petrol with ecu sagem sl96-1 9630650880


it has eeprom-plcc 28f256


plase to make immo off test in these ecu without car.


i need solution tested


pin-out uce


35,13 batery +


36,54 batery -


9 light chek


7 light pump


please i need help


How can I check that this immo cancelled correctly?


thanks

[samurai1991]

guys i have a SL96 - 3 ecu, car says electronic ignition fault. any leads where might be the problem

[Rojas2109]

Hi samurai1991. Have you checked the coil drivers? I could tell you where these are. looking from the side of the connector, 20mm from the right side and 50mm from the bottom, is one of them, the other at 72mm from the bottom.

[alexeybulatow]

I do immo off on all the blocks where tms is installed as follows. either close the flesh address legs with each other, or put them on the ground for a short time through the load

[gmarvin]

Will try on a Int Mod D.