DRS 6 and DDEC V files

[makura]

Hi guys
I am looking for a cal file for serial number 06R0776795 ddec 5 to calibrate using ddrs

[jabkissmya]

to make it easier on me, as cals are requested, i am just going to add to origional rar file to keep from having to go through and spend a lot of time hunting down the recently downloded files.

[makura]

to make it easier on me, as cals are reauested, i am just going to add to origional rar file to keep from having to go through and spend a lot of time hunting down the recently downloded files.

good looking out m8,thanks a million and keep up the good work!!!!!!

[alexxcool]

good work!!!!!!

[ukge4122]

Hi Guys,

I am looking for a Calibration / Flash File for a Detroit 60 Series Engine

Engine Series 60
Engine Serial # 06R0649874
Engine Model 606MK60

All help is greatly appreciated, and thanks again

Regards

[jabkissmya]

Hi Guys,

I am looking for a Calibration / Flash File for a Detroit 60 Series Engine

Engine Series 60
Engine Serial # 06R0649874
Engine Model 606MK60

All help is greatly appreciated, and thanks again

Regards

added to it

[peter21]

Hi friends, I'm looking for a calibration for ECM DDEC IV Serial Number 06R0686821 Model Engine 6063HK35 Genset Applications...... thanks in advanced.

[jabkissmya]

Hi friends, I'm looking for a calibration for ECM DDEC IV Serial Number 06R0686821 Model Engine 6063HK35 Genset Applications...... thanks in advanced.

added to it

[rudamie]

jabkissmya,

Thanks for all your good work in this thread. It's very helpful Woot Woot Share ON......!

[peter21]

jabkissmya, thank you soo much buddy.....

[dieselman77]

Can someone help me please ? I am wondering about reprogramming a ddec ecm can you plug into the dash plug to reflash the ecm or do you need to make a special cable ? thank you

[jabkissmya]

Can someone help me please ? I am wondering about reprogramming a ddec ecm can you plug into the dash plug to reflash the ecm or do you need to make a special cable ? thank you

the answer is both, you can plug into the trucks datalink and program an ecu, but is better if you have the bench cables, as better success rate, the only exception is mbe engines you have to have the cables to program. what ecu are you programming?

[dieselman77]

i want to reprogram a ddecV ecm to 515hp@1200 rpm and i think it was 1650 ft lbs torque i have not tried it yet i just want to make sure when i do it do it the right way i have bench cables for cat , cummins but no detroit thank you

[diagnosss]

Hi friends! jabkissmya, thank you so much! GREAT work for us!!
i need calibration files for S\N 06R0801865 and 06R1999999 (turbotest sw)
hope on your help

[torqueman]

HI ALL,
CAn sombody please provide calibration file for engine serial # 06R0750912.

Greatly thanks.
I want it so badly.