Can anyone get the stock cal file for my engine? Serial number 06r0167359
Sent from my moto e6 using Tapatalk
I have a DDEC 4 that has 2 engine ratings - one is 430 and the other is 430/470. is there any way to change it to just 470 with DDCT? I see in the calibration with DDCT it has ratings allowed at a value of 58. Does this need to be changed? Or is the only way to have a straight 470 HP is to download a totally different calibration? I would like to just modify the calibration that is in the truck now. Thanks
Can anyone get the stock cal file for my engine? Serial number 06r0167359
Sent from my moto e6 using Tapatalk
Hello,
i have a detroit s60 with an ecm no showing codes on dddl but on truck panel shows it have 2 codes related to abs. it retrieves all calibration will all parameters. the truck runs couple miles and will shutdown following a warning light and red light. it is possible reprogram the ecm to gete it fixed.
You can change the engine protect feature to warning only using DDDL.
i am using a DDEC 3 ECM on a DDEC 4 engine. The boost sensor only reads about 60% of the boost i am getting. What do I change with DDCT so the DDEC 4 sensor reads right with a DDEC 3 ECM? I looked under sensor processing and there is nothing for a boost sensor
Thanks
Hi. i have a ddec 4 ecm in rom boot and can only get rel 39 program it install but it wont take calibration. It stays in rom boot mode. Any help would be greatly appreciated
I am new to DCT, and am wondering if anyone can tell me how to actually download the calibration from my engine in a format that I can use and edit in DCT? The engine is a GK series DDEC-3, 1994 build; it is dead stock, 430 hp from the factory -- in fact, it's at ECM Software Version 8 (hasn't been plugged into since 1997).
Good day everyone. I do on highway vehicles but got a request for a S60 ecm with a 6063EK33 calibration for a front end loader. 06R0634213 is the engine number. Can someone please help with a calibration file. Thank you.
Bookmarks