XPROG-BOX CERTIFICATE

[ZIZZOU]

ok
now i have trayed direct com cable and crossed com cable
same result,no answer from xprogm

[spychu14]

Something is wrong with your computer or xprog.

My clone works OK with USB and COM.
Check on the other PC.

[ZIZZOU]

i have downoald a soft (virtual port) and instaled it on my computer
after setting paramaitres of virtual port,i run XPROM and i see that the green led comme ON when i start xprogm application ,
but it's always give "device is silence" and no led is ON when i clic on update!!!

[ZIZZOU]

finaly i get it
port com1 was desactived in bios

[Laca06]

XProg Soft Full
It works well.
The MAC solution is to wait
Xprog 4.5
Hotfile.com: One click file hosting: DB Software.rar
XProg 5.0
Hotfile.com: One click file hosting: DB Software5.0.rar

[stefaudio]

hi Laca06 this software post bi you is it without counter or wot i belive counter is in bootloader of atmega so everi software works well is the same everi time

[andrym3]

XProg Soft Full
It works well.
The MAC solution is to wait
Xprog 4.5
Hotfile.com: One click file hosting: DB Software.rar
XProg 5.0
Hotfile.com: One click file hosting: DB Software5.0.rar

Work fine but don't try to update firmware,risk to version 1.5

[bram380]

Don't copy 3 files.
http://www.digital-kaos.co.uk/forums...01/index4.html

[smayer]

Hi
It's possible read a Mercedes ESL ( electronic steering Lock), with Xprog-m by k-line?
Thanks

[stefaudio]

no m8 not posible ESL by kline

no k-line on ESL only CAN

[agabna]

Hi
It's possible read a Mercedes ESL ( electronic steering Lock), with Xprog-m by k-line?
Thanks

hello
i think if we try it can be because it can read ews with just 4 wire
so it better for all o try reading the ezs + esl for (210-202)
like it can be in (211) with special adapter

[borysgo2]

Small question:
I want to register my xprog but every time i am checking hardware id it gives me different one - is that normal ??
Or while registration i have to have reg window permanently open ?

[AGK]

Small question:
I want to register my xprog but every time i am checking hardware id it gives me different one - is that normal ??
Or while registration i have to have reg window permanently open ?

It is normal.

[ovi_dk]

Here its a good dump widawth reset counter inside for flash and eeprom for x prog 5.0with full autorization.

[H.Wessel]

because i know good programming of atmega the counter has register of enable that exists in flash .for example you must find the 0A word and change it to 02 .

i do not know which counter is energized timeo 0 timer1 timer 2 .

with .asm file its like a game to do this job

here is asm from ida, sincerely it don?t look so complex but in my test I haven?t found the right bad_boy_jump

best regards
H.W