Sorry with dumps I cannot help you. As I told you I don't share dumps.
"To help you with something" - what does it mean.
Good luck
Sorry with dumps I cannot help you. As I told you I don't share dumps.
"To help you with something" - what does it mean.
Good luck
ok.
Can you tell me what programmer would be able to copy dump?
Always atmega is blocked to read flash and eeprom.
There must be a solution
Hi all
I have a question. I have now Interface VCDS 11.11 PL/EN (language). It is on hardware which i show on images in link below:
https://goo.gl/photos/Lnb21G1m4pZvpCXu5
Is any chance to change this FW and done this interface to work with VCDS 17.1.3 ? Please help me step by step how i can do it. Sorry for my english
Yes you can
All the tutorials in the forum.
I am not an active member anymore. So I have no time to creat a tutorial.
But you will haven't Polish vcds active anymore.
Good luck
Matty
Last edited by mattydr67; 23rd May, 2017 at 06:29 PM.
Please give me link to tutorials... i try find but i can not.
Please
in first 10 pages you will find.
GOOD POST THANKS
Hi I have az oringinal Ross-Tech desing interface it's China -Clone...
My license is gone away by Internet....
Can you help me to bring it alive...?
The interface is visible, i can test it, but th license is DEMO...
Can you share me dump files?
The current FW is 1.96
17.1.3
ATmega 162
FT232RQ
thanks..
Last edited by nagyelek1982; 29th June, 2017 at 09:51 AM.
Hi all
I think about buying from china clone vcds. What do you think about it:
http://s.aliexpress.com/yMRJNvAV
It is probably new version... please help mr
Hi everyone. I have vag 12.12.0 chinese clone. worked fine for a while, and in one day when i tried to do a auto-scan, at some point showed me the message 'this function requires a licensed interface'. i checked 'about' and it shows unregistered. i used the software that came with the cable, which prompts to close internet con, and changes the date automatically. it's like a demo. i still can do some things whith it. any chance to make it fully working again? thanks in advance. sorry for my poor english .
Open it and check if there is atmega162 or NEC processor.
it has a warranty seal. and i didn't rip it of yet.any chance to find out the type of processor without open it ? i read the entire thread, and i know the nec's one are pretty bad. if it's a atmega, i still need to use a special tool to reflash?
Bookmarks