MERCEDES W211 SBC C2498 RESET

**vwpassat** · 17th October, 2012, 06:30 PM

What about C235C? Is it possible in DAS dvp? And how?
Thank you.

Originally Posted by mercis

only c249f,if it can
c2498 can you with developer make

**smayer** · 17th October, 2012, 09:45 PM

Originally Posted by vwpassat

What about C235C? Is it possible in DAS dvp? And how?
Thank you.

C2498 is service threshold reached. You can solve problem with Das if you unit part number it's not A 005 xxx....

**znoki** · 18th October, 2012, 04:23 AM

Originally Posted by vwpassat

What about C235C? Is it possible in DAS dvp? And how?
Thank you.

Solution sent in pm.

**mercis** · 18th October, 2012, 04:46 AM

and i have tested, work 100%
THX znoki

**znoki** · 18th October, 2012, 10:57 AM

Originally Posted by mercis

and i have tested, work 100%
THX znoki

Cheers Mate!

**ACDC** · 30th October, 2012, 01:30 PM

Is it really possible to reset C2498 in dev mode? I even have T-box, to program directly pcb of SBC (used to get rid of C249F before I read that it is possible in DAS dev too :S), but as far as I know C2498 is a no go. If there is a way for getting rid of 2498, please share with me too, as I am very interested

**rappttor** · 19th November, 2012, 07:22 AM

I used avdi trying to reset c2498 from a 2002 w211 SBC unit and it doesn't work, so if you have anymore solution please keep me post it.
Das common procedure dosent work also, tryed many times, c2498 still remains although the usage and time counters become 0. The problem is that this module has a pompe cycles counter wich I cannot reset, and it remains at 123%, das or AVDI same shit

**znoki** · 19th November, 2012, 09:39 AM

Can AVDI read / write the full eeprom file?
Did anybody try to write a new eeprom file in?

**albdiag** · 20th November, 2012, 10:19 PM

can any one reset this sbc dump? thx

**imoturbo** · 20th November, 2012, 10:54 PM

read your dump and reset it and after you will write it in your sbc modul with avdi tool 100% warrantly

**albdiag** · 21st November, 2012, 06:44 PM

Originally Posted by imoturbo

read your dump and reset it and after you will write it in your sbc modul with avdi tool 100% warrantly

was this to me?

my dump is attached

i want to reset it

**bali motor** · 21st November, 2012, 08:14 PM

Originally Posted by albdiag

can any one reset this sbc dump? thx

this new dump for your module

**feles** · 21st November, 2012, 11:48 PM

I did a reset on a MY2004 SBC.
During the test drive I got the red error message and the brake servo gone at 100km/h. Pump motor failed.
Everyone think about what could happen on the highway without servo brakes.

**albdiag** · 22nd November, 2012, 04:58 PM

Originally Posted by bali motor

this new dump for your module

i write this dump to the sbc with upa. write and verify ok

I install back in the car. and faulot was same C2498. I read eeprom via das and eeprom was back as it was originaly

What is wrong here