"I try to recalibrate the dump. First start is very well, but another is also bad as before. Today i will try to install 0.25mm shim in rotor as i read from lucas manual for repair and then new recalibration."
same problem...........
"I try to recalibrate the dump. First start is very well, but another is also bad as before. Today i will try to install 0.25mm shim in rotor as i read from lucas manual for repair and then new recalibration."
same problem...........
Today i try with 0.25 mm shim. Engine not start. I removed the new shim and install only original 2 shims. Now car starting very well and working very well. But i have only one fault code (OSM sensor access).
The engine ecu is repaired by another garage and i think that problem is in him. Maybe they remove eprom and communication between ecu and OSM memory missing. I will open ecu tomorow.
i am shure they are cut some track on pcb or broke some elements
i have try to calibrate rotor on 3 cars and not have sucsses , so good luck
I have sucess and car working very well.
i have same problem. the car starts only when the MIL goes off. what can i do?
Thanks
Hi to all.
Next week i will fit a second hand pump (rebuild) in Doblo 1.9 2001 with Lucas Epic pumpe.
Should I program the pump (93c46) or not to start the car.
Thanks to all.
Last edited by doktorabg; 24th November, 2016 at 08:14 PM.
[SIGPIC]
HELLO everyone. I'm not really sure how old this post is but I have the same problem on Fiat Doblo 2004 1.9D (223A6000). The fault codes red with DELPHI diagnostics are P0252, P0254, P0010. Apparantly there is a problem with the pump. The thing is that I'm not really sure what to do with it. Shall I remove it and send it for repair or the problem could be resolved without repairing the whole unit??! Many thanks
Hello
I have same problem with fiat doblo. Engine wont start without full throttle and hold idle. Diagnostic show P0252. I try calibrate OSM sensor. After calibration, 1st cold start is same. On the 2nd start, car idling and react on accelerator pedal, but the idle is erratic. Now diagnostic show errors P0252 and P1607.
Thanks for any helpful replies.
better results u'll get if solder hole electronics of rotor, recalibrate eeprom and soldering ecu conector points (behind sticker).
rgds,
cuby
audiopoint (17th April, 2018)
please could help me with change of position of rotor in memory 93C46 ?
I been trying already few to repair it by using mechanics method but without any luck
https://mega.nz/#!sVRzUKjB!x81QPEr2CHWfgDSOXP_XuZUVGTcmaI8CPMqQGac zlbo
BEST OFF ...
recalibrated,
rgds,
cuby
lordraidem (27th January, 2021)
This is the current topic for me in 2022.10.
508 9HD 1.6 HDI_SID807_BR2 ( 19 Faults )
today Subaru Forester 1999 sync. A pair of H44H and F93C46 is required.
A topic that interests me
EDC16 CP39 need ASAP2, ols, a2l, kp map
I can not find the description .... Lucas EPIC I. II and III
pls pass friend for epic 2
thx,
cuby
help pass pls thanks
Bookmarks