Carprog reprogramming - final solution

[elchip]

Before or after Lupu solution.

If you reflash Lupu solution after 300 uses is it back to 400?

Lupu never haved HIS SOLUTION ...
NEVER

[Meat-Head]

Lupu never haved HIS SOLUTION ...
NEVER

*CONFUSED*

I have NO problems with Lupu - he is too far away, but would be more than happy to hover over his shoulder and LEECH information off him

Now i'm not expecting a reply from Lupu as i'm currantly 'not' a DF forum supporter due to STILL got problems with Meaty Card thinking that www.meat-head-motors.co.uk are FICTIOUS!

They still REFUSE to issuse a card in the company name.

This the ONLY reason why have not paid again. If i can send cash call it done.

[olegario]

Just reprogged my CP, 5 minutes job, but lost hours in tries to connect CP to Wiggler. So if your Wiggler based on 74hc244 and you have problems with connection, just solder wire from CP's 3,3v pin(Erase pin on the pic) to Wiggler's 74hc244 pin Vcc (20).

[ahadi]

yes , after flash carprog last week today the counter come up , sorry Mr. the no counter solution not careful .

regards

[Meat-Head]

ahadi can you reflash and report back please on counter?

can you upload the 'used' dumhp thanks

[ahadi]

its good i keep wiggler interface for further re flashing and pin 55 still raised up with glued wire to the ground . the duMp is from here .

[Meat-Head]

flashing and pin 55 still raised up with glued wire to the ground .

did you use hot air or soldering iron to lift pin.

was understanding you could just tack a wire to said pin?

[olegario]

It's not a problem anymore if you have Wiggler, you can flash it each weekend. Lift pin 55 with thin needle, solder to it flexible cable and fix it with glue (as described in first topic) another point solder to GND or Erase point (depends what you need ) I think Chinese sellers must add Wiggler to CP cable set

[dexik]

Hi m8's

I do not know whether atmel sam-ice is a good programmer to do the job?

Help

[justy22]

Justy mate, did you manage to do yours yet?

mine came out for fresh air, then back to bed

No still not got round to this but will soon, have you had much use of it at work

[Meat-Head]

No still not got round to this but will soon, have you had much use of it at work

WRONG THREAD:-

Read a Vauxhall Astra 1.6 16 Valve pin code <PLEASED AS PUNCH SMILEY>

ON TOPIC:-

Guess you might take it to Tam for IN-correction, can you take note and photos please.

Suggest a line of Sno Pake on the AT822SC whatever thing to help identigfy ornatanion.

Should have a chamfered edge.

[gauch]

I have USBJTAG, do you think I can use it to program carprog or only wiggler works?

[ALEXEI]

I have USBJTAG, do you think I can use it to program carprog or only wiggler works?

work any tool which support this chip
I use Kiel. I think its the best
USB ARM JTAG programmer/debugger "Ulink mini" for KEIL

[gauch]

what about this one:
Ulink 2 USB JTAG Emulator ARM9 Cortex Keil Ulink II GH2 | eBay

[buga37]

what about this one:
Ulink 2 USB JTAG Emulator ARM9 Cortex Keil Ulink II GH2 | eBay

yeap, i was looking to buy this one too