brchip (20th November, 2017)
i do like this without any problem:
Erase mcu:Connect the Carprog (with the pin 55 disconnected) to the 12v supply, wait about 5-10 seconds and connect the wire from pin 55 to VDD in Carprog,
the flash content will be erased and the Jtag option of the Mcu will be enabled now. If not work leave connected for about 3 to 5 minutes.
1-GND(for normal connection)
2- to Erase-point VDD (for erase the MPU)
3- Lift it without any connection with the PCB (for programming) .
regards
Last edited by otojm; 20th November, 2017 at 10:19 AM.
brchip (20th November, 2017)
Thank you m8.
I found the problem: the JTAG settings.
I was using this one, and it didn't work:
H-JTAG2.JPG
When I used this settings it worked:
setings2.JPG
I reflashed my Carprog 7.28 with LIB 081105CAR001773I (is it actually 4.01?) and it seems to be working fine, no counter anymore.
My question is, can I reflash it with a different version, like the ONLINE 8.21 and LIB 150428CAR00491KW?
I guess not?
Does someone have a pinout to read 93c eeprom for carprog pls. I don't have a decent or standard cable.
Tnx
Sent from my EVA-L19 using Tapatalk
hi
needed hjtag software.
sorry for me bad english.
Does any one fancy doing this to my carprog? Im willing to pay
Gav
Hi thank you for this solution, ill try it in a couple days . Just one question, why this connection ? Thanks
Edit : I mean the top "bridges gnd"
Last edited by monstermurga; 16th January, 2018 at 02:31 AM.
A630V (14th September, 2018), monstermurga (16th January, 2018)
Hi, I have carprog 8.21 and I have some problems writing by Kline (I don't try another kind of writing). I tried to writing ABS bmw E46 by Kline in bench and Dash MB Vito MC68. My carprog can read fine, but can not write! Write without errors but read again and no change!
What can I do to solve problem?
hi,it happened for me with renault dash with nec, and i close/disconnect from power the dash and repeat the work again to have good write!
so perhapes this can be usefull for you to test...
PS:it looks like there's a service-shedull that must be done in first attempt then it do the right correction in second attempt !!!
regards
I have same Error, cant connect to carprog..I tried all connections that I can find on forum,,in the end pin 55 is broken, paid new mcu but i get same error message..
I use china clone segger jlink ,, can someone share jlink program which one did work for you ? maybe software is not good, my program is v4.26
Did you try this?
I found the problem with mine: the JTAG settings.
I was using this one, and it didn't work:
H-JTAG2.JPG
When I used this settings it worked:
setings2.JPG
Thanks mate, I use segger Jlink,, I dont have your software
Bookmarks