thank you i will try and tell you. I have now op-com ,but clone so i dont know ore work properly :/
thank you i will try and tell you. I have now op-com ,but clone so i dont know ore work properly :/
that should do job nicely mate, no worries should all be sweet now
DjRomeoR (15th May, 2013)
Thank you very much man ,car start now all ok, and airbag work good THANK YOU VERY MUCH ))))))
Your welcome mate, no problem, so i guess pin for sdm was correct? 2504? And programming the way i shown you was correct? And crash cleared?
Thank you for replying
Last edited by flyins; 15th May, 2013 at 09:17 PM.
DjRomeoR (21st May, 2013)
Yes all was like you say , Thank you .
flyins (21st May, 2013)
Hallo
After several attemps of bcm reset, airbag, ecu and so on,
I've tried Flyins procedure and i've to say you a word:
Works like a charm.
Godd work Mate!!!
My customer Corsa D after a dead battery have a immo (spanner) light blinking with no start condition.
Several error in ecu about: wrong environement identifier recevied
I've tried your procedure and the Corsa D came to life.
Many thanks
flyins (4th November, 2013)
what tool use for this job?
Carprog 8.21,xprog 5.55,galletto v54,kess and ktag rework
2 things with Corsa's. After resetting BCM always switch ignition off and remove key for half a minute to be on safe side. Also when programming dash you need a mint battery or charger connected. For some reason dash's don't program when voltage getting low (they do reset though - go figure).
V Series TMS470 / EEPROM data - encryption / decryption, totally pwned.
IEC 62056-21 - new discussion: sonsivri.to/forum/index.php?topic=60412.0
BusCan (12th February, 2019)
It is possible to read pin code from airbag? I have car with swapped airbag (vin is not same) and i can't reprogram bcm by Tech2. When tech2 going to SDM i have wrong code
Try 4273...
Bookmarks