I am using R270 for erase 35080 series... where is the picture??
I am using R270 for erase 35080 series... where is the picture??
sorry about the photo
Read again or/and clean the pins of the eeprom.
already cleaned several time! and experimented with several M35080 always the same problem, also resoldei resistances.
Anything else I can do??
thank you
080D0WQ is not a 35080. You need to select the right chip. Bottom right hand corner, advanced function, select 080/160 35080, you will then get a pop up box in which you should select the exact eeprom ie: 35080 V6/VP, D80, D160 35080 3/6. I have never had any joy erasing 35080 VP's or V6's with this kit (only partially erases) but D80's work everytime without fail and very fast. I can see by your picture that you are not selecting this properly.
rtbdiagnostic (1st June, 2019)
did just that selected eprom correctly, starts reading and read error.
You have asked for help reading a 35080 and your picture clearly shows that you have selected an 080D0WQ. You cannot do this with this kit. You must select the right chip.
yes i tried the correct version. I experienced M35080 (3.6) VP, V6, 080DW, all well chosen but always the same problem, before reading to reach the end (READ ERROR)
You might be better of sending back to supplier for exchange
Don't forget to hit thanks button
Experienced in CAS3 works well! But my interest in the function was R270, M35080 eraser v6, vp, 080d0WQ. When I experienced the first time reading M35080 did not read anything, then I re-weld or components entam now start playback, but for reading before coming to an end, as the image is then says: READ ERROR (((in 20 attempts, one ever read well))
There must be a problem with your unit. When I bought my R270, I did not expect it to erase 35080's because some people saying it would not work, but it has worked on every CAS. EZS, 080D and 160D chip I have ever done. And it is very fast.
When selecting eeprom select Type 2... also push down on the eeprom while inside the socket.
I tried all the possibilities, until welding directly on eprom adapter, but even before resoltado Finalize reading blocks READ ERROR, or noticed that my not have a component? or will be like? as in the picture, annotated in red. Anyone know the reference of the components noted in blue?
Bookmarks