this one that i have repaired...
this one that i have repaired...
darius89 (1st August, 2013)
Thanks, thats what I need.
And another one:
DSC02971.JPG
darius89 (16th August, 2013)
it's lot of work....
After repair i mount ecu on rubber mountings on engine .
Last edited by PierreTheron; 10th August, 2014 at 08:33 PM.
What do you use to remove the gel, and how you soldering so clean?
I must say very good job!
comon darius.....Its hard enought to repair 2-3 wires..you will realy solder them all???.....too much work ...I would never even try this much work...
If I was usefull be sure to thank me.......if I was not just do nothing, I can shot lighning and use mind tricks through internet........yea i can....
Hi, its hard when you need to solder 2-3 wires in middle, but not so hard to change all one by one. Max 2 hours
Hello
how solder?
Does anyone know the solution how to remove gel completely?
NO
only the hard way m8 ....
Bookmarks