Ford mustang

[tkmotors]

Hello everybody
Anyone know where is located immobilizer module on FORD MUSTANG 1999 3.8 . I have to make key as customer lost it so tried over OBD with obdstar but without luck.

[rob h]

You could scan the car, with diag tool.
if it shows the partnumber, perhaps it leads to partscatalog picture.

Can you follow wires, from the readingcoil, around the igniton lock.


Mustang 1997–2004 Immobox with tms inside.
4C transponders

[askkey]

Hello everybody
Anyone know where is located immobilizer module on FORD MUSTANG 1999 3.8 . I have to make key as customer lost it so tried over OBD with obdstar but without luck.

I think it is integrated with the transponder coil on the ignition switch if I remember correctly.

[tepSIJA]

TMS Ford Mustang

[tkmotors]

TMS Ford Mustang

I see this picture but where is located this module? I have traced the wire from key reader but is going to cluster so that’s why I need to know where is that module located.

[vialli]

I see this picture but where is located this module? I have traced the wire from key reader but is going to cluster so that’s why I need to know where is that module located.

askkey gave you the correct guidance

https://www.ebay.com/itm/28441384181...Cclp%3A4429486

[tkmotors]

I did see that but inside no TMS or eeprom so I think it’s only reader

[vialli]

Well, from this reader some wires definitely go to the immobilizer... maybe somewhere in the center console, behind the gear shifter

[tkmotors]

There is four wires so two goes to cluster then another two is power and earth

[askkey]

I still think it is on the ignition lock considering there are 4 wires (data and power) on the connector instead of 2 (only data), I assume there is a module integrated with the antenna over the ignition lock.

Do you mind posting pictures of the 2 sides of the PCB of the module over the ignition ? You might have missed something.

[tkmotors]

Ok problem solved
there is no separate immobilizer module as is integrated in instrument cluster
After full scan with Avdi pats is in PCM and IPC so I have programmed the key over OBD

[vialli]

There is four wires so two goes to cluster then another two is power and earth

In the end... the logic was confirmed