ok. here is a tip. if your gettin different reads all the time with SPC560P50L3.
make sure that all pins are clean, no pin should be dirty. make sure you remove all of the coating from chip and legs or pins.
DON'T JUST SAY PRESS IT.....
I have original smok programmer, new to it, trying to read a 2010 Toyota Camry renesas much solder all wires as shown on DOC but I'm not able to rear, I will post a picture tomorrow, maybe I will get better help here than smok support
Sent from my iPad using Tapatalk
Last edited by Plcautoparts; 16th November, 2013 at 03:55 PM.
A simple thanks would do, If it didn't work at least I tried.
Did you remove the resistor from the other side???
DON'T JUST SAY PRESS IT.....
anyone else having issues writing to SPC560P50L3 ???
i could read and verify any part of the chip.. the problem i have is when i write. verify gets errors all the time. i have zero success writing to data flash.
DON'T JUST SAY PRESS IT.....
Yes I did. I did an upgrade on software and was able to read it. I'm posting data to verify I read correctly.
Thanks
i did the software update. thinking it was going to fix the writing issue i have with SPC560P50L3. no i still cant write to data flash.
DON'T JUST SAY PRESS IT.....
that picture is not the correct to read it in circuit..check documents,,, that write UART in circuit only...
thats its a bad reading if you were able to read it like in the picture it was read wrong...
Last edited by AMLGAR; 20th November, 2013 at 05:36 AM.
Hello Amlgar, I connected as in DOC that came along the programmer, could you tell me what am I doing wrong please?if you have a picture of your set up will be nice.
has anyone with j-tag successfully write to data flash SPC560P50L3????
DON'T JUST SAY PRESS IT.....
br.balazs (22nd February, 2015), buga37 (17th October, 2014), chiorbeq (23rd February, 2014), cjohny (6th October, 2014), datapage (10th December, 2013), diag1001 (31st October, 2014), digikeys (6th December, 2015), Gary Diaz (13th September, 2019), hatimtai (20th February, 2015), jakesman (13th September, 2015), keycar (29th January, 2018), killlin (15th December, 2015), magdex (9th December, 2013), makz (23rd November, 2013), nicolaus (23rd November, 2013), pire cemil (21st September, 2016), SergeyIg (3rd February, 2023), taxo1965 (20th November, 2014), vavrich (18th May, 2018), wcysj08 (25th May, 2017)
Bookmarks