Are you kidding? Sure he can... He was able to copy it and paste it here, everything else is peanuts for him.
Are you kidding? Sure he can... He was able to copy it and paste it here, everything else is peanuts for him.
i have problem.i have xprog 5.0 clone. i install on win7 x 32bit, adobe reader 10. update ok. run error : unknown command. Software error. How to soved?
paulocesar (28th June, 2016)
problem solved. it work good
can i update xprog m with programmer tl866? its have atmega64 but i not know how to connect
Someone could help me with lock and fuse bits ?
I tried to program ATmega with usbasp programmer
Screen from bascom
tested on line, internet 100% smoothly.
Galee (12th January, 2017)
hallo, I have installed the new firmware 5.5.1 on clone
but when I start the software gives me all blocked
All works ok cas 2 cas3 read and write in first time Thank's Good job.
files are removed?
regards
audiotek (28th December, 2014)
Bookmarks