VW Fox immo box

[zippy82]

Hi got to have a look at a fox for a spare key, I belive pin code reading doesn't always work and on zed bull eprom/mcu they have fox and it's just a eprom, what I was hoping to find out is it hard to find the immo box and how difficult is it to remove just so I'm prepared.

thanks zip

[ttzag]

Behind dash little to right

sent from LG_G2

[zippy82]

Ok thanks, so best remove dash/clocks and then just remove the immo box, it doesn't look like a massive box on zedbull so shouldn't be too hard I hope

thanks zip

[p1et]

It's little box with 93c56 eeprom so won't be hard . Good luck.

[dam495]

fox until 2008 has imobox you can read ?pin code by obd , sbb will do it,,, but your fox was produced , after 2008 , you need to read the dash / or ecu to get your pin code

[zippy82]

It's a 2006/7 so will sbb clone do it? I forgot about trying sbb and even supervag pin reader but I'll give them a go

thanks zip

[zippy82]

Hi been back and couldn't see the box at all, is it hidden?

[vlado kljucar]

hello my friend vw fox from 2005....see if your cluster is MM have motorola processor mc9s12h256 remove dash and read !

[zippy82]

Hi thanks I thought that, I did take the dash out and saw it was MCU but didn't have time to start reading a MCU

Does anyone know the connections from my picture? I know it will be them 6 connections all together, also I don't think I've got a calc for fox or would a calc for VW beetle work as I have one for that MCU that's the same

thanks zip

[yugo45]

RED	VCC (5+)
BLACK	GND
PINK	BKGD
YELLOW	RESET

[zippy82]

Thanks I'll give it a go, just hope I've got something that can calc the pin

zip

[yugo45]

Thanks I'll give it a go, just hope I've got something that can calc the pin

zip

Post eeprom dump here after you read it.

[zippy82]

Hi never saw the other fox again but have another and it will not read using upa, normally don't have problems

[zippy82]

tried with carprog as well and just flashes display but does not read

MC9S12H256CFV
2K78X

[dragoshu]

Hello guys,
It can be read this mcu with xprog on board conections?if yes can you give bdm connection ?
I will apreciate the effor.
Regards,dragos