read bosch edc7 of maxxforce 13 engine?

[tuanneo0811]

hi everybody!
i want read flash file of this ECM via CAN or K line, anyone has solution of it?
Bosch 0281 020 098

[Alpinesport]

in 9 pol in cabin A= gnd B = +24v C = Can H D = Can L

On ecu C1 Can H = 34 / Can L = 47 / ign + = 17 / gnd 2-4-6 / V+ Bat 1-3-5

[Alpinesport]

[tuanneo0811]

Thank you, but I want to know which tool can read this ECM via CAN or k-line

[ominimicu]

fgtech can do. or u can BDM it!!

[tuanneo0811]

fgtech can do. or u can BDM it!!

Have you tried it yet, in the list of Fgtech truck without maxxforce 13, it is only for Man and IVECO with ECM EDC7uc32!

[ominimicu]

DOesnt matter the selection of vehicle as long as it s same ECU. tool will use same protocol to connect! yes tested!

[tuanneo0811]

DOesnt matter the selection of vehicle as long as it s same ECU. tool will use same protocol to connect! yes tested!

thank you so much! i will try it

[Elisium700]

how to connect to the unit to read the firmware? i have ktag. please help me.

maxxforce edc7uc32

[nomorenoless]

Hello guys,

Maybe I am quite late with his message , just about 7 years, but anyway, for other tunes to know, this ECU although is MaxxForce but the protocol is 139 Bosch EDC7/C32 yet is has a small difference with a capacitor, however, is almost the same. I leave here the ECU picture.

IMG_0775.JPG

Hey tuanneo0811 if you're alive can you pm me?

[Crossland25]

I have this EDC7 ECU and would like to read the current calibration file with my Ktag or kess. Would anyone be so kind as to provide instruction on how to hook up to it on the BDM board? I’d be happy to reembusre you for your time and trouble! Thank you